white out
- Posts
- 1,078
- Reaction score
- 22
Latest activity Postings About
-
-
white out replied to the thread New 99 RT/10 owner, few questions on issues/coilovers..You have done all the great driver mods that really make the car more enjoyable to own and drive. I think we have messaged about... -
For more than 20 years and at least 40 trips to the track, I NEVER bled the slave cylinder. I would use the turkey baster and put clean...
-
white out replied to the thread Hydraulic clutch.If you do not have an extended bleeder hose installed, the lazy way works fine for cleaning up the fluid. Get a baster. su[c]k all...
-
white out replied to the thread Request for help.Use Permatex copper gasket maker.
-
Mine always does this during stop and go, not in motion running. The Fans come on and it never goes above, but it goes to that spot and...
-
I managed to find the one piece. Their last one plus the last gear cluster to match , from The Gear Box from SC. Texas drive train...
-
white out replied to the thread Yet another overheat issue HELP.Its normal if you are at low speeds and higher external temps.
-
The moisture on cold start is normal and is a byproduct of the combustion process. All engines do it. The black spots is most likely...
-
white out replied to the thread Yet another overheat issue HELP.GEN 2 do consume coolant (at least my 4 have) which I assume is from the non-sealed design of the upper tank. You might just be low on...
-
If the car is pushing coolant into the lower tank and not pulling it back into the upper tank, you again likely have a leak in the main...
-
Are you getting any pressure release when you open that upper tank? Not sure if a faulty cap would cause that result.
-
white out replied to the thread Yet another overheat issue HELP.If your upper tank was empty and immediately pulled water in when you filled it, the water went to the motor, not the expansion tank in...
-
white out reacted to GTS Dean's post in the thread From what Material is the floor section made on a GTS Gen 2? with
Like.
That's not very bad damage and I'm almost positive the pans are steel. It could be bumped back out reasonably well in a few hours. Put... -
white out reacted to TEALLIFE's post in the thread From what Material is the floor section made on a GTS Gen 2? with Like.
Id honestly leave it alone. You'll probably risk more damage trying to fix it. If its dents, its metal of some type. if it cracks its...
-
white out reacted to MoparMap's post in the thread From what Material is the floor section made on a GTS Gen 2? with Like.
If it's anything like the gen 3 I would suspect it's likely steel. I had an "offroad incident" in my car many years ago that put a...
-
-
Loading…
-
Loading…
