Recent content by kwkshift
-
K
The 2nd quickest all motor Viper?
IIRC, that's a stroker motor like what's in my car with nitrous on top of that.- kwkshift
- Post #14
- Forum: RT/10 and GTS Discussions
-
K
I'm seriously getting sick of Vipers being looked down on. Sick of it.
The next time someone talks **** about your Viper just ask them 1 question: "And you drive a _____________?" On the off-chance they're some snotty Porsche driver or whatever, just ask them: "Does your wife know you took her car without permission?" OR "Cute car....does it come in Mens?"- kwkshift
- Post #19
- Forum: General Viper Discussion
-
K
supercharger vs turbo
It's a cog drive. It's supposed to be like that. Gotta love the blower-surge at idle!:headbang:- kwkshift
- Post #16
- Forum: Performance Modifications
-
K
Anyone know about this Carbon Fiber Intake?
Actually, the spacing of my holes and the studs line up correctly, but the airbox sits at a weird angle. For example, lets say the top of the radiator where the 2 studs are located is parallel with the floor, the mating surface of the airbox should match that and be parallel with the floor as...- kwkshift
- Post #19
- Forum: RT/10 and GTS Discussions
-
K
Anyone running Dual Widebands WITH DISPLAY?
How about this one? FAST: Gasoline and Methanol Alcohol Air/Fuel Meter (two sensors)- kwkshift
- Post #2
- Forum: RT/10 and GTS Discussions
-
K
Anyone know about this Carbon Fiber Intake?
I have ne of these, myself. I was actually trying to get it to fit yesterday afternoon. Hoop, does yours sit properly on the 2 studs that are on top of the radiator? I couldn't get mine to sit down on there because of my Roe upper radiator hose I know what you're talking about when you...- kwkshift
- Post #16
- Forum: RT/10 and GTS Discussions
-
K
Dyno Nitrous Results...very disappointed
What's wrong with 100% from 3000-5600 rpm?- kwkshift
- Post #28
- Forum: RT/10 and GTS Discussions
-
K
HUGE CRACK in my HOOD!!! ***??
Is that a crack in the hood or in the paint?- kwkshift
- Post #13
- Forum: RT/10 and GTS Discussions
-
K
Aldan Billet Aluminum Shocks
I noticed that there is one know with even numbers and the other has odd numbers on them. Where should these be set for a street/ strip car? I have looked on the Aldan website, but I can't figure it out. Thanks!!- kwkshift
- Post #7
- Forum: RT/10 and GTS Discussions
-
K
Rotrex supercharger
I wouldn't want to reinvent the wheel. Just get a base Roe, slap it on in a day and be done with it.- kwkshift
- Post #8
- Forum: Performance Modifications
-
K
Rotrex supercharger
They look way too small. You would have to put 2 of thier biggest compressors on there to get any benfit.- kwkshift
- Post #2
- Forum: Performance Modifications
-
K
how much RWHP does it take to run 130mph traps?
I've raced a Paxton SRT-10 that dyno'd about 700 and it was a good race until about 120+ and then my car started to pull away. Not by a lot, but there was nothing he could do and the distance just grew and grew.- kwkshift
- Post #18
- Forum: SRT10 and SRT10 Coupe Discussions
-
K
how much RWHP does it take to run 130mph traps?
My GTS makes 600 N/A rwhp and it has gone 135 on a less than perfect tune.- kwkshift
- Post #13
- Forum: SRT10 and SRT10 Coupe Discussions
-
K
What % of Vipers have over 10k miles on them?
My 97 GTS just rolled over 46,000 miles. The car is very clean, runs 10's on 91 octane and is actually very reliable. The only problem I have had with it in over 2 years of ownership was the crank position sensor went out. That's all! Garage Queens are like girls that have their dolls on...- kwkshift
- Post #95
- Forum: General Viper Discussion
-
K
Supercharger
ADS in Chandler. ADS Automotive Diagnostic Specialties - Automotive Services & Repair - Chandler, Arizona.- kwkshift
- Post #2
- Forum: Performance Modifications
