Recent content by ozzie
-
O
Denver Colorado Gen 1 owner looking for a shop
3R race shop, Shawn at ford dealership in Colorado Springs, Mike Hoover? @ Mercedes, and Gene Konecny a member at the other club- ozzie
- Post #2
- Forum: New Owner Questions
-
O
New Colorado Member!
Aloyed21, Here is what I've found for you sorry it took so long and will let you know of others when I talk to a couple of members. You should join the club wealth of info. Here is what I found out so far. ford dealership of all places in Colorado Springs has a mechanic. Shawn is I believe the...- ozzie
- Post #6
- Forum: Generation V Discussions / SRT Coupe, GTS, GTC, AC
-
O
New Colorado Member!
I'll be getting back to you on mechanics this week but nobody up north just the Denver area- ozzie
- Post #4
- Forum: Generation V Discussions / SRT Coupe, GTS, GTC, AC
-
O
New Colorado Member!
Are you in the Denver area- ozzie
- Post #2
- Forum: Generation V Discussions / SRT Coupe, GTS, GTC, AC
-
O
2009 Viper codes, Help, Codes: 0043, 0047, 0052, 0261 Airbag Warning light.
You may have to replace module under passenger seat which is kind of a pain to replace have to pull nuts and bolts then tip it back or pull it out of car.I prefer tipping it back. Good luck there is not much info on these cars. Module is about $170.00- ozzie
- Post #5
- Forum: SRT10 and SRT10 Coupe Discussions
-
O
Left Headlamp - 2008 SRT-10
Don Scharff may have one. Pain in the **** to replace but very doable. Just make sure you have the shims if any put back in the same place under the headlight.- ozzie
- Post #2
- Forum: What'cha Need for Your Snake?
-
O
WTB: 2008-2010 SRT 6-spoke brushed polished OEM wheels
I had to find my fronts in Canada and one wasn't perfect spent alot for not being perfect they are hard to find in good condition, A set went through Copart on a 2010 but it had front end damage and doubt they didn't get bent, mine had to get straightened so be wary of used wheels without some...- ozzie
- Post #4
- Forum: SRT10 and SRT10 Coupe Discussions
-
O
Sourcing Obsolete Parts For Gen I and Gen II Vipers
Call Don Scharf used Viper parts ask for Todd- ozzie
- Post #215
- Forum: RT/10 and GTS Discussions
-
O
Help with Codes on 1997 Viper GTS
Check these out this is what I looked up and found hope this helps.:repost: p0107=low voltage to map sensor p1296=air/fuel management control system P1488 Auxiliary 5 Volt Supply Output Too Low ...P1496* 5 Volt Supply, Output Too Low- ozzie
- Post #10
- Forum: General Viper Discussion
-
O
Headlight Lens Covers
Well you are going to have to buy a used or new headlight assembly the lens is glued to the rest of the assembly from what I see on my 2010 I'm repairing.- ozzie
- Post #4
- Forum: SRT10 and SRT10 Coupe Discussions
