Recent content by SNKEBIT
-
VCA back to the same old routine
OMG!!!!! JonB!!!!!!!!!!!- SNKEBIT
- Post #63
- Forum: General Viper Discussion
-
heat shield to sill panel adhesive?
what 2 screws?- SNKEBIT
- Post #6
- Forum: SRT10 and SRT10 Coupe Discussions
-
-
Are Baby has made the cut its in Gran Turismo 6 Check it out
When does that come out?- SNKEBIT
- Post #4
- Forum: Generation V Discussions / SRT Coupe, GTS, GTC, AC
-
Little video of my Twin Turbo Viper..
He will!!!!- SNKEBIT
- Post #11
- Forum: SRT10 and SRT10 Coupe Discussions
-
-
Special paint application
Send it to my shop. Be a better paint job and cost a lot less.- SNKEBIT
- Post #10
- Forum: Generation V Discussions / SRT Coupe, GTS, GTC, AC
-
lowering cap install help...
Have you moved the car? If not, the suspension is binding from being jacked up. Drive it around, it should settle in.- SNKEBIT
- Post #15
- Forum: RT/10 and GTS Discussions
-
lowering cap install help...
Take the nut off the bottom of the lower control arm!!!!!!!!!!!!!!!!!!!!!!!!! Screw the nut off until it is flush with the end of the stud and tap upwards with a hammer, finish removing nut. You have to do both sides at the same time. Rotate the sway bar out of the way and remove lower shock...- SNKEBIT
- Post #8
- Forum: RT/10 and GTS Discussions
-
gen 1 dash removal(light switch help)
That is a gen 2 switch. Bottom of knob you turn lights on with has a little hole in bottom, stick real small screwdriver, etc. in there to release clip.- SNKEBIT
- Post #4
- Forum: RT/10 and GTS Discussions
-
gen 1 dash removal(light switch help)
Pull the light knob out like you turned on headlights. Reach behind and find the small button on top, iirc, of the electrical part of switch, depress button and pull the knob and shaft the rest of the way out. If you haven't unhooked the battery, your lights will be on until you disconnect the...- SNKEBIT
- Post #3
- Forum: RT/10 and GTS Discussions
-
mounting dimensions GEN4 exhaust tips ona GEN3
Every car is different. Put the tip on so you can still move it around to position it. Put the sill on the car with a couple screws. Position the tip so it is towards the front of the hole and center top to bottom. (You want it towards the front because the pipe expands when it gets hot and...- SNKEBIT
- Post #2
- Forum: SRT10 and SRT10 Coupe Discussions
-
Reprint of inside door sticker?
^^^^^ This!!!!^^^^^^- SNKEBIT
- Post #3
- Forum: General Viper Discussion
-
Draining gas tank on '98 RT/10
I use the Christmas tree push in fasteners instead of rivets. Some black silicone around the perimeter and push the pins in, looks like it should be that way.- SNKEBIT
- Post #11
- Forum: RT/10 and GTS Discussions
-
Draining gas tank on '98 RT/10
Thought there was a check ball in the fill tube to prevent gas coming out in rollover???- SNKEBIT
- Post #4
- Forum: RT/10 and GTS Discussions
