Recent content by speedfreak99

  1. S

    Should stub axle have any play ?!

    Good advice. Called unitrax . Tech mentioned to remove halfshaft , tap stub axle back in and remove c-clip on end of stub to prevent halfshaft from pulling on stub if c-clip binds up. I will update after I try this.
  2. S

    Should stub axle have any play ?!

    The stub axle ( gen lll ) coming out from the diff housing which the halfshafts slide onto on the passenger side has moved about an 1/8 of an inch outward . I can see the old line where it used to be from the old mark the housing seal made on it. Just had diff rebuilt and wondering if there is...
  3. S

    Brake & Rear Diff Fluid

    Cool thx for the great info :)
  4. S

    Brake & Rear Diff Fluid

    "mopar 75w85 synthetic manual transmisson lubricant" is what I have found for t-56 trans in Dodge fluid index. Anyone else weigh in on this ?
  5. S

    need rear differential advice...

    I drove car up on a set of Race Ramps 10" high and just floor jacked rear of car up with two jacks and blocked it on rear jack points with short pieces of wood, 6"x6" cross hatched 3 high. I had enough room to do the job properly. Its really not a bad job at all . There are some great threads on...
  6. S

    need rear differential advice...

    I just had the same problem. I figured may as well learn how to work on the car so I removed the diff housing and took it to a good driveline shop to install all new guts that I purchased. New wavetrac diff, 3.55 gears and master bearing kit and seals .I ordered the parts from Josh at Roe...
  7. S

    Need your input on rear diff bang . I did search forums. Need help

    UPDATE : Removed rear diff . Took it in to shop to install new wavetrac. The spider gear inside the oem hydra-loc were broken and chewed right up. Halfshafts and U-Joints appear ok.
  8. S

    DIY halfshaft questions

    Thank you Sonoman ! Job went exatctly like you deacribed it thx .This forum is so helpful thanks all:)
  9. S

    DIY halfshaft questions

    Got it !!! Thanks guys :D That is a huge help and great detail. Got the service manual and I will keep reading up as much as I can find. Cheers Marc
  10. S

    DIY halfshaft questions

    Thanks for quick reply Bryan! Alright great to hear from someone who has done this , would i even need to remove the rear wheels ? Sounds like I could just pry the halfshafts out from diff housing ? How far are the halfshafts in the housing ? Should I get new c clips for original halftshafts...
  11. S

    DIY halfshaft questions

    How did the job go ? Did the halfshafts just pop out ? I am wanting to remove my whole housing to swap out gears and diff.so by the sound of it i could pop off rear halfshafts and unbolt diff housing and remove it and take to the shop right ??
  12. S

    Need your input on rear diff bang . I did search forums. Need help

    Update : i just do street driving. I ordered the wavetrac and all new parts including 3.55 gears. Didnt bring viper into shop till my parts arrive. Is it possible for me to attempt removing the entire diff housing and bringing it to a shop to install all new guts and for me to bolt up again ? I...
  13. S

    Need your input on rear diff bang . I did search forums. Need help

    Thx Dan im looking into the wavetrac .
  14. S

    Need your input on rear diff bang . I did search forums. Need help

    It bangs hard starting out and when letting off accelerator. Yes i do get wheel hop sometimes when i drop the clutch..Ok maybe not half shafts then good to know thx. The car is going into dealership on friday. Thanks guys for the responses i will post the problem when i find out as much as i can...
  15. S

    Need your input on rear diff bang . I did search forums. Need help

    Hi guys I did a burnout and heard a bang from the rear end. Put car on ramps removed bottom driveline cover and had a buddy let clutch out slow to see where the loud driveline bang is now coming from . Checked all mounts and ujoints . As clutch is let out and engine torque builds up with the...
See more

Latest posts

Members online

Total: 732 (members: 13, guests: 719)

Forum statistics

Threads
153,202
Posts
1,681,955
Members
17,704
Latest member
Fessup605

Share this page

Top