"The Stock Throttle Body Shaft and Bearing will be retained and used in this new Throttle Body"
i am not sure what people picked up with this throttle body with a supercharger. They claimed 9rwhp on a NA i believed. I would assume getting rid of that center post and opening up the hole with a...
Roe Racing sells the single blade for $380, I am going to order that down the road for my paxton
http://www.roeracing.com/productcart/pc/Billet-Aluminum-Throttle-Body-03-06-Viper-SRT-10-04-06-Ram-SRT-10-190p368.htm
I have a gen3, i was able to get into reverse and i backed up. Then i tried to get into reverse and now i am unable to. I pulled the solenoid out and ran 12v to it and i can push it down just fine. i have no check engine lights. I put a test light on the plug and it lighted up just fine. So im...
I have a 06 Coupe Paxton on stock pulley, catless, exhaust, and on stock split box on 93 gas.
My gap on the plugs seems to change extremely way too fast and causes my car to bog when i step on the gas.
NGK ZFR6F-11G Gap at 0.032 ( what Nineball was using in his setup)
This ran great until...
I was wondering if anyone knew what the GPH or GPM is on the original Paxton water pump is for the heat exchanger? Im looking to upgrade mine to get a better flow rate then what came stock.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.