Search results

  1. W

    Gen 1: Dash cam wire routing?

    Dash cam is easy to route up to the top you just have to remove driver seat to wire up the ignition wire
  2. W

    Rear Diffuser for Gen 3

    Custom formed aluminum
  3. W

    Wiring Pin out for Pedal adjuster

    Wiring diagram
  4. W

    Rear Diffuser for Gen 3

    Here are some photos
  5. W

    Dash wiring question

    That looks like the radio antenna module and the small snap like connects to the windshield
  6. W

    Who's done Gen 3 Magnaflow cat back ?

    Have done magnaflow 12867 14 inch with high flow and yes very loud drone, but love the sound and solves the the hot sill problem my legs don't get burned.
  7. W

    another post about windows raising too far on 06 coupes

    My problem on my 06 is when I row the windows up with the drivers door left open, then shut the door it will hit the top frame of my coupe . We should row it up with the door shut therefore the window will drop down .
  8. W

    Twister tried somthing new

    An R8 nice ride.
  9. W

    A little bling...But not too much!!

    Looks nice!!! I like it.
  10. W

    So what kind of issues can I expect after having the battery disconnected for days??

    Re: So what kind of issues can I expect after having the battery disconnected for day The manual always recommends disconnecting the battery is safest way especially if the intake is off for over a week, there always some chance someone starts the car or fuel leak etc..... there is always...
  11. W

    Exhaust upgrade advice needed

    You should attend some viper club meetings and hear different sounds first, its all personal preference. I had to change mine three times to get it right, as Allan says get rid of crossover first.
  12. W

    Rear lower control arm has a gash in it, does it need to be replaced?

    You also need a suction gun to fill the transmission and the diff,http://www.mactools.ca/en-ca/Specialty-Tools/Steering-and-Suspension/GS19HD/Heavy-Duty-Suction-Gun make sure on the diff you remove both drain plugs as its divided in two sections then fill on the next drain plug with red...
  13. W

    Rear lower control arm has a gash in it, does it need to be replaced?

    Mine is also an 06 I would have to search for receipts , I used the dot 4 for clutch and brake I have the mityvac 7300 that has a fitting for the brakes to vacuum the brake fluid. I used the mopar ATF+4 tranny fluid for power steering according to the viper tech, the grease is NLGI-LB grease...
  14. W

    Rear lower control arm has a gash in it, does it need to be replaced?

    I just did all my fluids last week, it took the two of us around 5 hours including lubing the suspension,It costed under 300 dollars in parts and picked up a mity-vac to vacuum out the clutch,brakes and power steering.
  15. W

    The new guy

    Congrats on your new viper. Its not only the crossover, you should also get 3inch highflow cats if the exhaust is stock .
  16. W

    New 19/20's and uvbnbit hooked me up!!!

    Nice pair of vipers!!!! the cool wheels may require extra care to keep brake dust off. :)
  17. W

    2006 First Edition, Who Has One?

    Congrats on your fe#146, beautiful viper. I have the next one up #147.
  18. W

    Proud owner of a new (to me) 2006 UGR TT Vert Viper

    Awesome machine! Congrats on your new toy.:2tu:
  19. W

    Sad Day today.

    Yeah i seen the utube videos and everyone fell for it.:)
  20. W

    Car would'nt start. ASD fuse or relay?

    The ASD fuse should stay at 25A this circuit feeds the PCM and the ASD relay will feed other circuits on the same fuse such as injectors ,coil pack, and the O2 sensors check the wires near the exhaust first ,you should carry extras fuses and a test light for the near future, good luck.
  21. W

    battery disconnecting switch

    The problem with the battery disconnect switch if it is too easily accessible, it will disable the alarm system and your viper will be open season from vouchers.
  22. W

    Front Wheel Bearings

    Thanks for the info Allan
  23. W

    Did a little photoshoot this summer, just wanted to share some pics

    Very cool shots:2tu:
  24. W

    Front Wheel Bearings

    Just curious when should the front bearings be changed???
  25. W

    Build thread for my accident repair.

    Awesome job!!! well done . that street looks so familiar. I am sure I work not far from there. If so I wouldn't mind checking it out.

Latest posts

Members online

Total: 1,029 (members: 4, guests: 1,025)

Forum statistics

Threads
153,836
Posts
1,686,656
Members
18,447
Latest member
naimsito

Share this page

Top