Search results
-
E
Importing a Gen 5 to Sweden
Anyone that knows what needs to be done to the car to get it through inspection (reg. besiktning)? -
E
10 cylinder EGT logging
We cannot have a PC connected while logging since it's a race car. Besides, I believe we would need 10 differential channels and that one only have 8.- eckeph
- Post #6
- Forum: RT/10 and GTS Discussions
-
E
10 cylinder EGT logging
Thanks! That looks interesting. Not sold outside USA though... I'm in Sweden. It should be possible to get someone to buy it for me but I guess that it would be difficult to get support.- eckeph
- Post #5
- Forum: RT/10 and GTS Discussions
-
E
10 cylinder EGT logging
Going to add EGTs and log the temperatures of each cylinder. I have searched but so far the only solutions I found are for 8-cylinder (or less) engines. I have the EGTs (bought from AEM) What I need is ten channels of thermocouple (K type) amplifier with ten 0-5v outputs. Preferably as...- eckeph
- Thread
- Replies: 5
- Forum: RT/10 and GTS Discussions
-
E
Idle pb with AEM engine management system
From the AEM 30-1500 EMS manual: The Viper idle air control motor is sometimes susceptible to drift and/or sticking. If your idle control hangs abnormally high or low during operation, turn the key to the ON position and wait approximately 10 seconds before starting. The EMS will reset the idle...- eckeph
- Post #3
- Forum: RT/10 and GTS Discussions
-
E
Supply and ground for ECU in a 1996 GTS?
Btw, you can discard the fact that it's AEM electronics (if that's whats holding you back:)). Since it's plug and play the connectors are exactly the same as a stock ECU. No one with experience of working with the engine electronics that can offer any advice?- eckeph
- Post #3
- Forum: RT/10 and GTS Discussions
-
E
Supply and ground for ECU in a 1996 GTS?
Starting to connect the wires tomorrow morning. Would be sweet if someone could stop me if I'm wrong! :)- eckeph
- Post #2
- Forum: RT/10 and GTS Discussions
-
E
Supply and ground for ECU in a 1996 GTS?
I already posted this over at the AEM forums but nobody answered my question so I though I would try my luck here :) We have a AEM EMS 30-1500 (pnp) that I'm going to install. Can anyone tell me which pins on the 30-1500 that I need to connect to +12 and which needs to be connected to...- eckeph
- Thread
- Replies: 4
- Forum: RT/10 and GTS Discussions
