Instructions on how to modify fog lamps to come on w/o turning headlites on?

[Gerald]

Does anyone know this procedure? If you do, are you willing to email or post it?
Thanks
Gerald

 

[Qualitywires.com]

I don't think that will work for the 1994 gerald. I was told ours are different.

 

[Gerald]

I think for Gen I's those are located in the trunk correct? I'd had cutting things if I wasn't 100% sure..

Gerald

Hey Doug, Your right, when it's cold out, I can't keep the tires on the ground...!! It's like have a shot of Nitrous!

 

[Gerald]

Thanks, I'll give it a try

Gerald

 

[Gerald]

Didn't work. don't understand how you can take out a wire and put in empty spot 10, when 10 is totally blank. Doesn't have the female ends, etc. just nothing. Also, which wire is the Fog lights, the Purple or Red? If I cut or splice it, where can I attach it to? I cut and thought I could attach it to another 20amp spot... nothing... Any ideas?

Gerald

 

[Chuck Greggs S Arizona ACR]

You are very welcome.

Chuck

 

[Chuck Greggs S Arizona ACR]

<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by Gerald:
Didn't work. don't understand how you can take out a wire and put in empty spot 10, when 10 is totally blank. Doesn't have the female ends, etc. just nothing. Also, which wire is the Fog lights, the Purple or Red? If I cut or splice it, where can I attach it to? I cut and thought I could attach it to another 20amp spot... nothing... Any ideas?

Gerald

<HR></BLOCKQUOTE>

Gerald,

I did mine about 3 years ago. I cannot find the written procedures, but I will look at my '94 later today. I was just using my failing memory. Laurie's husband was able to read between the lines(I suppose?).

Chuck

 

[Chuck Greggs S Arizona ACR]

Gerald,

I checked my '94 fuse panel. After disconnecting battery, drop the fuse block down, You will see a red wire with blue stripe going to the #2 position. Move that wire, including the terminal that the fuse plugs in, to the #10 position. You have to release the little locking tabs to remove the terminal. Move the 20 amp fuse to #10 slot. Reconnect battery and check lights. Should work only with ignition and fog light switch on.

Good luck,
Chuck Greggs