Need specs for housing bore

[Pompe]

Hello
I bought a new crank and bearings, but one of the bearings gets to small when we put it in place. We tryed with the others, and the result was the same.
Is there anyone who has the correct spec for the housing bore and the main bore? The engine is a -01 but i have a replacement engine wich is a -00, so if the specs are different, i would like them also.

Best regards
Pontus Q
Sweden

 

[LETHAL GTS]

Try here:
http://[******]/index.php
This is where most of the big tuners hangout.

 

[Pompe]

Sorry, can´t open the link.

 

[99 R/T 10]

try www.viper alley.com BUT squeeze the viper and alley together

 

[Pompe]

I must be an idiot. I cant find it on viperalley, but there is a reference to viperclub if i need to find engine specs ;-)
Anyone else?

 

[99 R/T 10]

I must be an idiot. I cant find it on viperalley, but there is a reference to viperclub if i need to find engine specs ;-)
Anyone else?

Lethal was trying to say(I think) to ask this question over at the alley. The people that know the question are over there more than they are here.

 

[LETHAL GTS]

That's what I meant alright!

 

[Greg Good Cylinder Heads]

I'm no engine builder, but I can read from a bearing book. Per the Clevite manual:

Gen 2 Main Bearing Housing Bore: 3.1925" - 3.1930"

Gen 2 Rod Bearing Housing Bore: 2.2500" - 2.2505"



Crankshaft diameter (stock)

Mains 2.29996" - 3.0004"

Rods 2.1240" - 2.1250"



HTH

 

[Pompe]

Well well, i am an idiot. I should have figured that out myself...

Thanks Greg, exactly what i needed