TDC for each cylinder, Zero lash between the rocker and push rod and then do your turns. I think Arrow says two turns. Mine are on about one turn and make a little noise at cold start.....I am going to try 1.5 turns. You did change pushrods ?
I have T&D's did the one turn got noise did the turn and a half now its quiet , just make sure your oil is still flowing to the shafts by cranking the engine at the starter and looking at the rockers
Cheers guys all done and running again so far so good....
It had new push rods,mopar valves+springs ported&flown heads 2000 headers blah blah blah.....
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.