How to set up Arrow roller rockers???????

[VIPER BAZ UK]

Is it just a case of DTC take up the slack and then two turns????

 

[1TONY1]

TDC for each cylinder, Zero lash between the rocker and push rod and then do your turns. I think Arrow says two turns. Mine are on about one turn and make a little noise at cold start.....I am going to try 1.5 turns. You did change pushrods ?

 

[fe155]

I have T&D's did the one turn got noise did the turn and a half now its quiet , just make sure your oil is still flowing to the shafts by cranking the engine at the starter and looking at the rockers

 

[VIPER BAZ UK]

Cheers guys all done and running again so far so good....
It had new push rods,mopar valves+springs ported&flown heads 2000 headers blah blah blah.....