Looks a lot like mine. Except for the shoulder surgery part.
1) HID conversion
2) urethane motor and trans mount
3) Dynamat sound deadening under rear carpet
4) smooth intake tubes
5) 3:55 gears
6) new clutch
7) new floor mats
8) Billet power steering pulley and bracket
9) change all...
Yes. I have a set taken off a new Viper back in '08 I think.
Was going to use them on my 2nd Gen but changed my mind.
PM me your email and I will send you photos
Anyone know where I can purchase the sealer tape used on the doors between the stanchon and panel. The electric door switch failed on my '01 RT10 and I tore the tape when I peeled it back. See attached photo
Thanks
This is what the back of the cap looked like when I got it. I trimmed the black plastic to fit the cavity in the car. I didn't modify the car in anyway. I then got some industrial two sided tape to work as a seal as well. Used a little soap and water to fit the cap without the tape...
So I purchased a Drake Automotive fuel door for a late model Challanger from Summit.
Fit is real close. Curve is good and size is slightly more than 1/16" all around. I made a seal to fit.
I replaced the head unit with a Kenwood KDC- X997 unit in my RT/10. More for the MP3 and Bluetooth capabilities. Kept the OE Alpine amp in the trunk as it seemed to be fine.
I replaced the speakers with a Focal P 165 V 30 set. Great clear sound. Big improvement.
Also I packed the cavity behind...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.