The Viper's differential cover is also it's mounting bracket.
There are some diagrams on this page: http://www.viperpartsusa.com/catFrame.php?prodCat=7F
You could get a doughnut spare from a Gen II, or maybe from a Dakota/Ram. Other makes of truck perhaps. Not much else out there with 6 lug rims on non-truck vehicles.
Edit: I don't know if a gen 2 doughnut would clear the brakes on a gen 3.
While I have a doughnut in my gen 2, I also carry...
I want to install an oil temp gauge because I notice my oil pressure drops a bit after a few runs in autocross. Pressure doesn't come down far, but it goes lower than normal.
Where is the best place to mount the temp sensor? Before or after the oil cooler?
Thanks
I was at Viper Days at VIR and my drivetrain was making noise. Jon B told me to talk to Archer Racing, so I asked the guys at Archer Racing for help diagnosing it. They put it up on their lift and diagnosed it as a bad pinion bearing. They advised me not to drive the car until it was fixed...
My car is a 2000, with the 10qt oil pan.
One of the guys that I usually race with blew the engine in his BMW due to oil starvation during an autocross event. While I have a long way to go before I reach the limits of the car, I figure an Accusump would be cheap insurance. I do notice my...
Does anybody sell a Viper-specific install kit for the AccuSump? Thinking of adding one for some extra protection during autocross events. The stock oil cooler lines are very stiff, so I don't see being able to flex them enough to fit a tee in place without different length cooler lines. I am...
I ended up replacing the springs with a set from the hardware store. I had to use two sets of springs (one inside the other) to provide enough centering force, and it's just barely enough. My transmission is very notchy and I could not rotate the shift rail with just my fingers. The original...
My shifter will not center left to right unless I give it a little help. I figured it was weak centering springs, so I pulled the shifter to have a look. Turns out I have a B&M shifter that I didn't know about.
I called B&M support to see if I could get stronger springs and they have no...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.