Re: Question about \'94 RT/10 exhaust.....
www.summitracing.com
well i literally just finished pulling the stock stuff off and to tell you the truth it doesnt sound too bad with open headers......so with that said im going to go ahead and clamp up the 4 foot pipe I bought and go from there if...
Re: Question about \'94 RT/10 exhaust.....
ok i decided after looking how close the stock muffler and cat are to each other, to cut them out as a whole....
so ill be cutting before the cat, and putting in 2.5 inch tubes($10.95 x 2)....and either a borla Xr-1 ($130 x 2) or a dynomax bullet ($33...
Re: Question about \'94 RT/10 exhaust.....
so your saying because "it burns clean" I could pass the sniffer test w/o cats ?!?
o btw what size piping should I get 3' right ? Im cutting right between the cats and the muffler.... and where the muffler was replacing it with straight pipes, and...
ya but seeing he is a '00 he can only run 5psi right ? wouldnt his $$ be better served spending the money he would on the top towards a piston upgrade... and depending on the avaliable octance up the boost ?
Question about \'94 RT/10 exhaust.....
I am pretty new to the viper forum...... more used to the LSX platform, so my question how do u guys think about this exhaust set-up...... i will be pulling of the side-sills and removing the stock mufflers on either side, keeping the stock-cats... but now...
I am completely new to this style of engine coming from the GM LSX platform..... our cams were super easy to install and our only upgrades were springs, p-rods and the new cam...... what is necessary with the GEN I motor and where the hell do u even get a cam for said engines ? also who tunes...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.