Recent content by GTS02

  1. G

    Dave6666 tried to unload cat's on me....

    AND THEY WORKED GREAT ! THANKS DAVE . after going to a few Viper shops , spending a few hundred on trouble shooting. the conclusion came down to needing stock cat's . Dave was kind enough to give me his old cat's ( worthless in Texas) and shipped them to California. I replaced my fuel filter...
  2. G

    Won't pass calif. smog, now what???

    So I contacted another smog shop that does Vipers on the phone and faxed the smog results, After looking at the failed test results from the dealer, I was told to ck the fuel pressure at idle and 1500 rpm , ck all fuel injectors so they are misting properly. and possibly change an 02sensor. Call...
  3. G

    Won't pass calif. smog, now what???

    like I said, you always seem to have the right answer, thankyou for the offer. I will try to pm you. thanks again.
  4. G

    Won't pass calif. smog, now what???

    Here is acopy of what they wrote. I hope it transmitts: SECTION OPCODE TECH TYPE LIST NETA CUSTOMER REQUI:ST SMOGIN$PECTION AND CERTIFICATE 30-111 CAR FAILED SMOG. RECOMMENDED STARTING WITH CATALYTIC CONVETERS. 720 CPJ </SPAN>hrs. 95.00PARTS: </SPAN>0.00 </SPAN>lABOR...
  5. G

    Won't pass calif. smog, now what???

    Anyone have any good stock cats for sale????
  6. G

    Won't pass calif. smog, now what???

    Gee, thanks dave, you always seem to have the right answer, thanks.
  7. G

    Won't pass calif. smog, now what???

    Well it was time to smog the Viper, I took it to the Ontario Dodge dealer and it stayed there for three days. They said it almost passes. OK so what parts are on the car, is their next question. I have 2002 GTS, 17k miles, K&N air filters, Corsa Exhaust, Ramdom Tech SHF catalytic Converters...
  8. G

    who's Viper got stuck on calif. 57 frwy

    I was heading to the beach to visit relatives when I noticed a nice graphite gray on the side of the 57 freeway getting hooked up on a flatbed. What Happen? Out of gas? I have come razor close to running out of fuel so many times.
  9. G

    Pinched Upper Window Moulding

    Dave6666, The amount of clearance is always the same hot or cold ( at least it seems that way. If it does change with the weather ( like I do ) I can't tell). Wizard, thanks I'll call & get the manual.
  10. G

    Pinched Upper Window Moulding

    I have a 2002 GTS, the door itself fits , closes, and opens perfect. The problem is that the window always squeezes the upper window moulding near the top mid to top back of glass area. To get the window in the moulding ,I have to lower window a touch and then raise it after door is closed. Is...
  11. G

    Raising Viper on Jack Stands?

    Thanks for the detailed write up. It was really simple with your step by step instructions. I'm back on the road and the car feels great:drive:
  12. G

    My doors are falling off.

    When I adjusted my door so it just cleared the bottom, the top of the window pinches the rubber seal and if I lower the door to allow the seal to fit the window, the door rubs at the bottom ( is there a window glass hieght adjustment?). this is on the drivers side only, the passenger side is...
  13. G

    Error Code PO441 , Fix?

    I am getting an error code PO441. It has to do with the EVAP system. Where is the purge solenoid located ? Thanks
  14. G

    Someone won a set of spark plug wires...can't remember who it was for?

    Re: Someone won a set of spark plug wires...can\'t remember who it was for? ab, I just wanted to say thanks again for my free replacment wires with the heat shield boots. I have had no problems and the wires look and work great, thanks again. :2tu:
  15. G

    Mobil 1 gear oil ok in Diff. & Trans????

    I tried the search files, I have a gift load of Mobil 1 gear oil 75-140 Super-Syn. Is it ok to put it in the differential with the Mopar lock-up additive. Also is this oil ok for the Trans.
See more

Latest posts

Members online

Total: 835 (members: 12, guests: 823)

Forum statistics

Threads
153,218
Posts
1,682,065
Members
17,714
Latest member
potterb4

Share this page

Top