Recent content by lmaurer

  1. L

    Help? No Brake Lights!

    Just noticed that I have no brake lights. Checked bulbs and fuses and they are okay. What may be causing this and how do I check on components such as the brake switch? Is it likely that I could have a broken wire or a bad ground? Are these conditions likely or is it more likely that it is...
  2. L

    Gen I Coolant Change Procedures

    Thanks for the information. I found that I could not refill from the Heater inlet. It just seemed as though the water or coolant would not flow in that way. I raised the front end and filled as much as I could into the radiator. I know I will have to fill the overflow as the system burps...
  3. L

    Gen I Coolant Change Procedures

    Do any of you have any suggestions as to the proper method for changing the coolant in a Gen I engine? Mine is a 92. Book says to pull the heater hose at the water valve and refill from there. Should the engine be run until hot, thermostat and heater open, then drain and refill? Is it...
  4. L

    spark plug cross threaded

    Thanks to all of you for the information. I believe I have successfully retooled the plug bore with a plug chaser. The car seems to run fine with no apparent problems. Here is what I did. Hopefully, these steps will help anyone else who may have the same or similar problem. I did grease the...
  5. L

    spark plug cross threaded

    Chuck, Thanks for the information. The plug hole I am working on is number one cylinder top left driver's side. Difficult area to get at withlarge radiator tubing and brake master cylinder in the way. Can I use a ratchet and proceed very carefully? How can I be sure I am running in to the...
  6. L

    spark plug cross threaded

    Hugh, Thanks for the information. I will try that and hopefully, it will solve my problem. Lonny
  7. L

    spark plug cross threaded

    Recently purchased a 92 RT/10. Changing plugs today and found that one is slightly cross threaded. Anyone ever had this problem? What did you do to correct it? I know I must be careful not to get metal shavings into the cylinder, but can I recut the threads? If so, what tool is best to use...
  8. L

    92 Viper RT/10 Suggested Maintenance

    I recently purchased a mint condition 92 RT/10. I am not sure of the maintenance done or the history of maintenance. I want to change the coolant, oil, brake fluid, clutch and rear axle fluid (if suggested)and any other that should be done. Does anyone know the proper procedure to change the...
  9. L

    side exhaust cover paint blistering on 92 RT/ 10

    Has anyone had a similar problem? On my 92 RT/ 10 the drivers and passenger side exhaust covers have some paint blistering to the front of each cover. What is the correct paint to use? I know driver's side insulation is available. Does it help with this problem? Is insulation also available...
Top