It can't be done without modifing the seat reclining mechinism. That part of the seat is wider than the space between the frame rails in the gen 1&2's. Take out the reclining mech and make it so its permanently set in one position and then you can mount it to the floor.
That's wht Jances first...
Re: Preventative tip regarding the window reg clip breaking - Lubricating the assembl
I never take the inside door handle off. It comes off with the door panel then unhook wire.
They don't fit between the frame rails. The mech on the side of the gen3 seats are too wide. Because of this, you can't get them down into the car far enuff. They sit too high.
Paxton blew a seal. DONT DRIVE IT!!!! 2 locals here have had bad pistons because of oil in the cylinders causing detonation. Paxton doesn't stand behind thier product very well..............
It basically has the same type of sensors. I would just lengthen/shorten wires and change the sensor plugs in certain wires to run to new locations. The gen 1 computer will still operate the gen 2 engine.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.