Just wrapped up a project and was about to pull the car off the lift. The battery was dead so I hooked up a charger to do a jump. The dash lit up like normal, ht all I got was a lot of clicking when I hit the start button.
Work in progress. I would appreciate some quick help. Either...
My budget allows, but it seems like kind of a waste. I found a good deal through a forum member, so I can buy two used shafts for about what a new one would cost. My labor is free and it seems like a simple swap.
Also, it seems like the problem is usually scenario rather than the part...
Thanks for the heads-up. I was searching for "halfshaft" instead of "axle" and didn't see much.
My two ebay options are:
Paul: $348.37
Xvipers: $382.36
I am new to the viper community so I am not familiar with either vendor. Any reason I shouldn't go with the cheaper one?
It's an 03. I only have an intake at this point but will probably add a full exhaust and dyno tune later this year. I probably will never be above 500rwhp. I mainly use the car for weekend driving and track days.
Judging by my experience and the experiences of others on this forum, it...
Did a search and found a write-up on the repair procedure. Seems straightforward enough.
I still need some suggestions on where to find a decent deal on a drive's side halfshaft for a 03. Any help would be greatly appreciated.
I hit a 1-2 upshift too hard this weekend and heard a nasty snap and looked to see bearings jumping down the street.
Where can I get a good deal on a halfshaft and is there anything viper-specific I need to know for the install?
Just for future reference:
A stock Viper SRT-10 Roadster is allowed at VIR as long as you can pass the broomstick test.
I would NOT have been able to pass if I didn't install the 2" seat drop kit. The first instructor I had didn't make it a full lap. We got black flagged at the oak...
Will do the roll bar at some point. I just won't be able to do it before this weekend.
I'm going to lower the seat with a 2" kit so I can pass the broomstick test. I am 6'3" so i need that anyway. I'll do the roll bar before the next track day. Thanks for the help and advice.
I bought an 03 a few weeks back to use as a track car. I am signed up for a track day at Virginia International Raceway this weekend, but am worried I may not pass their rules for convertibles. The event organizer said I just need to pass the broomstick rule. But I have also seen info online...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.