Search results

  1. R

    clutch/brake pedal assy

    Thanks Jon b.@ The PartsRack for the referral, shipping out tomorrow! Ryan was out but Paul was helpful.
  2. R

    clutch/brake pedal assy

    For a 94 rt10 what is this part called. What is the best source in getting one? Mine wore through the bushings then the metal over a quarter inch. It was ok until I put in a new clutch,slave,and master, but I think the thickness of the new disc will not allow me to get into any gear with the...
  3. R

    Trunk Top Design (Gen 1)

    I have the one piece and windows,a little different but the pro/con should be close. The front latches were hard to adjust using the instructions, the back latches didn't pull the top flush without trimming the fiberglass and then the latch assy's had to be modified to pull all the way. The...
  4. R

    Does a CEL clear on it's own after some ingition cycles?

    What he said,turn the key to start for a few seconds will with it off will seal the deal.
  5. R

    Finally went for a drive today!!

    Great wheels! Took me a while to figure out the shadow graphic....Basketball anyone?!
  6. R

    what is current rec for oil/filter for 96 gts?

    So you had my post deleted...hurts when the truth comes out.Just go to oil changers(any of them) and shut the .....up.
  7. R

    Help!

    A day of soaking, and a bigger hammer, bell out and then clutch and pressure plate out!
  8. R

    Help!

    Boxer12..I'll give that a shot!
  9. R

    Help!

    Yes,99..the trans is out. Six bolts to the block,tried a long pry bar gently. I can't even tap a putty knife between the surfaces.
  10. R

    Help!

    I have all the bolts removed from the bell housing to the engine block, and it won't come apart! My frustration level is near max:crazy2:
  11. R

    Jump starting dead battery 02 rt10

    gen2lover..Really?....Hope you don't run out of gas, filling up might be a challenge too...:lmao:
  12. R

    Transmission R/R

    I just got back to it and yes, that #8 bolt has been hiding from me! Top passenger side, I thought all were out because gently pulling the tranny seperated from the bell housing over 1/2". Lucky I didn't try to force it:omg:. Thanks TONY and Tom and the rest!:2tu:
  13. R

    Transmission R/R

    1Tony1, I have the 7 removed. Lowered the engine/tranny as far as it will go and still I hit the frame!!!
  14. R

    Transmission R/R

    Rob,yes I'm supporting with a floor jack with a platform I made. Tom, It is the tranny and the bell housing I can't seperate.:(
  15. R

    Transmission R/R

    Hi, I have followed the service manual(1994)to remove the trans, I had some trouble with the slave disconnect that Tom helped out with.:). I lowered the motor/trans as far as I can and the trans only comes out about 3/4" then the housing hits the passenger side frame and I am stuck:crazy2: Any...
  16. R

    94 Slave cylinder

    Thanks Tom, took a while for my brain to figure out what you wrote. Then the light went on! Two minutes later....success!
  17. R

    94 Slave cylinder

    I'm dropping the trans and at the step to disconnect the quick disconnect for the slave cyl..I don't have the special tool, is there an alternative? Thanks in advance!
  18. R

    Future most collectable cars article on yahoo

    Read the article, You own the 9th and 10th. still not bad:D
  19. R

    Future most collectable cars article on yahoo

    The article actually lists it as the #10 most likely....still not bad.:)
  20. R

    Happy New Year

    May this be the best year ever! Happy New Year!
  21. R

    A Shot To The Tree Huggers

    If you lived in the San Francisco/Bay Area your whole life it makes sense. That's the point, It's Emerald Green, but as far from "green" like a tree hugger wants. Good news! You're not color blind:D
  22. R

    A Shot To The Tree Huggers

  23. R

    A Shot To The Tree Huggers

    Got my new plates today, Just in time cause my bud next door just got a new Prius yesterday.
  24. R

    New Mach 7 Top And Windows.

    Seal at the top four sides look good, but the bottom and trailing edge on mine will need extra weather stripping. I don't plan on driving in the rain...more like insurance for those iffy days. I didn't get the scoop because it only comes with the three piece top and I didn't want to have to...
  25. R

    New Mach 7 Top And Windows.

    Soft and padded black liner! Hope you're not too tall...I'm 5.7 and it's hard to get in and out... once in it's OK. Blind spots,yes there are more.....I still recommend this product.:2tu:

Latest posts

Staff online

Members online

Total: 1,057 (members: 11, guests: 1,046)

Forum statistics

Threads
153,842
Posts
1,686,690
Members
18,454
Latest member
Mopar SRT

Share this page

Top