Anybody running 3" pulley on paxton with the Stock Paxton BOV?

[FastMatt]

I'm looking to go from the 3.25" pulley I'm running now to a 3". Has anybody done this with out up-grading the BOV? How about the Paxton crank pinning? will I need to pin the crank with thicker pins?

 

[plumcrazy]

stock paxton BOV here. no problems at all.

bigger pins might be a good idea but keyed is best. now that i think of it, bigger pins might weaken the already marginal crank snout. call doug levin and see what he says, he'll talk to you about it. tell him i sent ya.

 

[JohnnyBravo]

I run the 2.75" blower pulley with the stock Paxton BOV without any problems. My crank is keyed and I use an AFI damper on my UGR built motor.

 

[FastMatt]

I run the 2.75" blower pulley with the stock Paxton BOV without any problems. My crank is keyed and I use an AFI damper on my UGR built motor.

wow what kind of power does that set-up make?