Homemade Driveshaft loop (98 GTS)

[Bolt]

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[hardtop]

Looks good.

 

[Racer Robbie]

That is a nice piece. I would put one at each end of the drive shaft as I have seen both ends break on cars. You should make and sell them, for both Gen 2 and 3, to our members. At a reasonable price it would be worth buying one instead of taking the time to build one. I would want black if it was me though.

Robbie

 

[plumcrazy]

tell me how much, i might buy one from ya

 

[Bolt]

tell me how much, i might buy one from ya

I got enough materials to throw one together for you for $50.

 

[plumcrazy]

you have a PM

 

[Racer Robbie]

So can you make one for a SRT?

 

[Bolt]

So can you make one for a SRT?

I don't have any more materials. I'll see if my buddy want's one on his SRT and if I make one for him and it turns out OK I'll let you know.

 

[Racer Robbie]

Please do that. I will be very interested in buying one in black for my house car. I should be located closer to the middle of the drive shaft so one is protected if ether end brakes. If I like the product I may be interested in selling them through my website, if you are interested.

Robbie

 

[Bandit400]

Looks good, just for info. BMR Fabrication makes a belly pan and drive shaft loop for $250. I put it on when my car was at Heffners. The belly pan is laser engraved with the Viper logo. Here is the link if anyone is interested.


http://www.bettercart.com/store/go?s=bmr&c=21626_8542&b=&a=NONE&n=product&product=8411

 

[plumcrazy]

mine's getting powdercoated as we speak.

 

[CrimePays]

Bandit400 thanks for the info. I ordered my BMR loop and belly pan. I had been looking all over with no luck. I am also in CNJ. Do you run at Etown often?