Replaced UPPER & LOWER CONTROLLER ARM and now i have a rattling noise

[Mamba55]

My wheel alignment was off and i had to get the upper and lower controller arm on the passenger side wheel. But after this is done i took the car for a spin this weekend and noticed a rattling sound. I am definelty taking it back to the shop tomorrow morning but before i do this anyone have any ideas what it could be. It just sounds like something is rubbing together or not enough grease not sure what it is.
BTW i saw a little of the tire ripped up on the wall didn't go all the way through but want to know about that too. Will i need to replace the tire.

Thanks all in advance.

 

[Chuck 98 RT/10]

You're in NJ? How far is that from Tator's?

 

[Mamba55]

i am in passaic nj.
I don't know exactly where Tator's is.

 

[Viper Specialty]

more than likely, they forgot to tighten one of the control arm/shock bolts bolts to spec, or the sway bar linkage is loose. Tell them NOT to screw around and use a damn torque wrench. WATCH them do it, they WILL blow you off if you dont stand there, I can gauarantee you that.

 

[Mamba55]

Thanks for that i really appreciate it.

 

[Chuck 98 RT/10]

Tator's is in South Salem, NY. If that's less than a two hour drive then it's worth it to have Chuck do your maintenance.
www.tatorsdodge.com

 

[Mamba55]

thanks for the heads up for south salem ny.
I was wondering if there is some just as reliable in the the new jersey area. Either that or i am going to have to buy a trailer to make life easier for me.