Where to buy o2 sensor extensions?

[V10SpeedLuvr]

I'm going to need at least one o2 sensor extension when I install my Borla headers next weekend. Anyone wanna point me in the right direction? TIA!

 

[Joseph Dell]

Radio shack. get some wires, some connectors, and a crimp tool. 30 min later, you are all extended!

JD

 

[CROM]

You could try these: Casper Electronics 02 Extensions

JD's solution sounds like the easiest (and cheapest) if all you need to do is extend the wires a bit.

I always used these POSI LOCKS rather than standard crimp connectors.

 

[InjectTheVenom]

So you bought the stuff you were talking about in the other thread ?

 

[plumcrazy]

i thought you had to solder the connections. something about any sort of interference would throw off the sensor.

 

[ViperTony]

Chad, DC Performance carries O2 sensor extensions. When I installed my Borla headers, I didn't get a check engine light until about 500 miles after installing them. Something about the position of the sensors in the Borla header location not getting hot enough. Dan at DC Performance recommended puchasing his quickfire sensors. I took a different route, I installed a Belanger system. But Dan was very knowledgeable about these headers and had all the parts I needed for them, including collector gaskets.

- Tony

 

[V10SpeedLuvr]

So you bought the stuff you were talking about in the other thread ?

Yep. Should be here tomorrow. Gonna go to a friend's house this coming weekend and install the headers and delete the cats at the same time

Chad, DC Performance carries O2 sensor extensions. When I installed my Borla headers, I didn't get a check engine light until about 500 miles after installing them. Something about the position of the sensors in the Borla header location not getting hot enough. Dan at DC Performance recommended puchasing his quickfire sensors. I took a different route, I installed a Belanger system. But Dan was very knowledgeable about these headers and had all the parts I needed for them, including collector gaskets.

- Tony

Thanks Tony, I'll give Dan a call if JD's idea wont work

 

[Camfab]

Dan no longer sells the extensions.