installed T&D's 1.7 last year after installing my S/C , used the stock push rods and tightened them down one full turn and had noises till warm and sometimes even longer especially after sitting for a few days.readjusted them down another half turn and had great oil flow and never had...
Thinking of selling my \'02 FE GTS...............
Just turned 5k miles , have original window sticker of 79k and original purchase contract of 82k plus fees. About 19k worth of extras including Roe 5# super charger with all upgrades , T & D rockers with needle bearings in the tips ...
Re: dyno\'d with Belangers and hi-flo cat and 3\"corsa \'02GTS
I will have to check this on the next run which will be in a few weeks with some new plugs . i did see and hear the misfire a couple of times and by the time everything seemed right it was the third run and the engine was good and...
Re: dyno\'d with Belangers and hi-flo cat and 3\"corsa \'02GTS
max torque was 545 at 2800 rpm and was jagged after that . Rwhp about 535 ,but it to was not a good curve. just not a good run as i said traction was bad and a periodic misfire but putting the graphs on top of each other showed good...
dyno\'d with Belangers and hi-flo cat and 3\"corsa \'02GTS
Although i was not happy with the overall peak numbers due to traction problems and a couple of misfires over 3000 rpm the addition of the belangers , hi-flos and 3" corsa resulted in a rwhp gain of 28 and rwtq of 37 mostly below 3200...
dont have pic's posted yet but i painted mine and now you can see them . Looks great and was worth it , i painted the rears also . Just keep the pads black and tape off the bleeder valve and the brake lines or it will look like earl sheib did it . I lightly scuffed mine with some steel wool then...
I have T&D's did the one turn got noise did the turn and a half now its quiet , just make sure your oil is still flowing to the shafts by cranking the engine at the starter and looking at the rockers
Befor you go and remove your lifters try this. I put a set of T&D's on a while ago and my car is not driven often , everytime i started it there would be lifter noise sometimes long sometimes short but it was annoying and not right.
When i upgraded the fuel injector clips with the Roe...
I also put the matching 100 watt Momo/polk , the magnet in the back is about the size of the spare tire so it took some surgery to install it but the sound is incredible . If you have not installed a complete system befor you may want to get some help and just dont replace the tweeters . i...
i replaced the door tweeters with the Momo polk system , i silicone glued them in place, i also ran all my wires through the boot in the front of the door to the center where the radio goes and down the center console up to the rear behind the seats , this is where i mounted my amp and crossovers.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.