-
-
Badinternet reacted to Bruce H.'s post in the thread Watch for something new on the nose of Vipers this year. You may see the initials RHS proudly displayed front and center on Vipers of every Generation with
Like.
I'm posting this note on behalf of Ken Nowak, Original Team Viper Engineer. "Who was RHS and what does he mean to Viper? Roy... -
Badinternet replied to the thread Pulling your car out of storage? Jump starting? READ THIS FIRST..Saved thread, thanks for the PSA.
-
Badinternet reacted to Viper Specialty's post in the thread Pulling your car out of storage? Jump starting? READ THIS FIRST. with Like.
Hey guys, Well, its that time of year again... pulling the cars out of storage, and also time of the year for damaged PCM's and other...
-
Like this:
-
Badinternet reacted to JDMB20TDA's post in the thread New to the Viper forums, looking to knock on this guys door and give him a offer for this 8 year yard ridden gen 2 with Love.
Shoot, why not both?
-
This. When cleaning just spray the outside with a cleaner, properly rinse out by directing water to the inside. Do not directly rinse...
-
The bulkhead is going in now, need that separation between me and all the stuff that burns in the rear hatch area.
-
Well the high from 252 MPH is starting to wear off and we all know what the next number should be. I'm looking into what it will take to...
-
I think the recommendation for rake is 3/4" higher in the rear, at least as far as track and suspension setup goes. Maybe not as...
-
25mm/1"/1 finger would likely be a more noticeable drop and still have plenty of ground clearance.
-
My 04 is probably somewhere between 0.25-0.5" lower than stock if I remember correctly and I haven't really had much for issues. Still...
-
Badinternet reacted to JoeTango's post in the thread First Viper - 2000 RT/10 - So Far, So Good with Like.
Last fall, I turned 40 and decided I’d been stalking Vipers long enough and finally bought one. I picked up a 2000 RT/10, black with...
-
Badinternet replied to the thread My Viper continues to hate me.As an aside, the plan was to do .5in lower with coil overs. Is there a consensus on ideal height to reduce wheel gap but also not scrape...
-
Dang I've never seen that before. Time for a new-used wishbone and have a close look at the knuckle.
-
Look at it this way, at least it happened while it was at the shop on the rack and not while you were driving. ***** either way though.
-
-
Loading…
-
Loading…
Latest posts
-
-
Want to ID this brake duct part that was vendor made- Latest: Tom and Vipers
-
-
-
-
-
