By the way the reason you have to tighten the bolts extremely well is that the shock mounts have slop in mounts holes are larger than the bolt itself so will make noise if not tight., then also if the bolts were not tightened at the proper height the rubber will not work right on the a arms my...
Ok I have it done now here is what I discovered If you are replacing with aftermarket rear shocks 2003 to 2010 no need to get nuts just take the rubber grommet out above the shock which will allow the top of the shock to go up into the car to get it out of the car. The if aftermarket shocks...
If you are only a few minutes away come on over I have a sunbeam tiger I just finished be selling that and have a 67 GT 390 mustang I finished my son has a 57 chevy and a 67 vette he is selling just text or phone 973 769 0092
Well I got into it this morning and 6 hours later I tried to take out the sway bar link but it wqs stuck in there I removed the upper A arm bolts and it gave me almost enough but I had to take the links out but they were now twisted so I took a sawzul and cut it in half the top one came...
Put a large pipe wrench on the shock body and then put about a 3 foot long pipe on the pipe wrench total about 6 feet and it will come off then take a nap
Has there been a link ever on how to install factory rear shocks on these cars I would think that sometime between 2006 and the present someone would have obtained an original set of factor shocks and installed them especially when the cars where newer and they were available.
At 81 it was 6 months ago and my memory just cant remember what I did to get it out. But after that the aldans are much shorter so they just bolted in perfectly holes lined up but when I put the aldan next to the stock shock could see the difference. It takes tremendous pressure to compress...
2006 coupe. I need some advice I have been fighting with the rear shocks since January. I have posted about it several times. I bought the aldans and just want to go back to the originals. But I destroyed them taking them off the forks. So I just bought on ebay a good set of originals...
I am getting back to the forum on the viper aldan shock problem it has now been 7 months of very hard work in exchanging and repairing this rear shock issue. The aldan people are very nice but the G3SBR2 rear shock for the 03 to 10 comes with a 750 lb spring about 9 inches long for the...
Just a heads up In 2006 I had store in Morristown New Jersey called embroid me make up the Viper logos and other Viper related stuff that could be embroided on anything hats coats shirts etc I paid for it and it is there if anyone wants to send them stuff to embroider or buy from them stuff to...
Just a reminder about the aldan with no forks. Before you can take it off the fork you have to take the coil spring off. Not hard but just another pain to do. used a mcpherson strut compressor to do it . I did not see any other replacement shocks that come with the forks installed that did...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.