Recent content by kmagnuss
-
K
Dash vent popping up, any fix?
Mine does the same thing and also around the passenger side tweeter. Annoying but it's a Dodge at the end of the day.- kmagnuss
- Post #3
- Forum: SRT10 and SRT10 Coupe Discussions
-
K
TPMS Woes? READ THIS FIRST, *before* you waste a bunch of time and money
I prefer electrical tape or an old photo of somebody I've never met. (I assume we're talking about blocking off the warning lights on the dash?)- kmagnuss
- Post #12
- Forum: SRT10 and SRT10 Coupe Discussions
-
K
TPMS Woes? READ THIS FIRST, *before* you waste a bunch of time and money
Hey Dan- I live just North of you in Englewood. Is this something where I could just bring my car over to you to perform, or do you need the sensors off the wheels to make it happen? Thanks. -Keith- kmagnuss
- Post #8
- Forum: SRT10 and SRT10 Coupe Discussions
-
K
FOR SALE: 2010 Viper Acr Convertible #2/20
While I appreciate the enthusiasm, we're probably not there yet... but will be someday I'm sure.- kmagnuss
- Post #3
- Forum: Classifieds
-
K
Right passenger door gen 3 dodge viper
Mine came off on the driver's side. It was a pretty easy repair. They just have one bolt holding them on (on the bottom of the handle) and then the top sort of wedges into the door panel. I made a cheap L shaped bracket to hold the bottom on a little better and then epoxied the top part on...- kmagnuss
- Post #2
- Forum: General Viper Discussion
-
K
Tapping noise
Mine does something similar but I can only hear it with the top up.- kmagnuss
- Post #7
- Forum: SRT10 and SRT10 Coupe Discussions
-
K
After 20 Years I Finally Got One
Lol I wish I knew. I spilled some of it when putting it in... because I'm super smart. If I had to guess, I'd say I put in around 5 oz (1 oz over recommended I think).- kmagnuss
- Post #24
- Forum: SRT10 and SRT10 Coupe Discussions
-
K
After 20 Years I Finally Got One
Agreed with above... I didn't put enough friction modifier in mine when I changed the fluid and it grinded around slow turns. I added more friction modifier to it and it 90% went away.- kmagnuss
- Post #18
- Forum: SRT10 and SRT10 Coupe Discussions
-
K
Priming Motor that sat for 6 months. Did I screw up?
You're fine.- kmagnuss
- Post #8
- Forum: SRT10 and SRT10 Coupe Discussions
-
K
After 20 Years I Finally Got One
I looks so much cleaner than mine, lol.- kmagnuss
- Post #11
- Forum: SRT10 and SRT10 Coupe Discussions
-
K
Leaking valve cover gasket, even after replaced?
Leak is gone... I was smelling some residual oil getting cooked off.- kmagnuss
- Post #13
- Forum: SRT10 and SRT10 Coupe Discussions
-
K
After 20 Years I Finally Got One
Congrats! Looks like Florida in your pictures.- kmagnuss
- Post #4
- Forum: SRT10 and SRT10 Coupe Discussions
-
K
Leaking valve cover gasket, even after replaced?
I must have had some residual oil on there because it's dry now after two 30 mile trips. I still smell a little oil cooking but maybe there's some residual oil cooking off deep in there that I can't see. Will monitor and check back in if something changes.- kmagnuss
- Post #8
- Forum: SRT10 and SRT10 Coupe Discussions
