I had Dan Lesser install the Jesels on Saturday. No problems with the install.
As a note, although we measured the pushrods at 7.5" Dan used 7.6" - they were a better fit.
Drove back the 90 miles to Toronto, engine felt fine, seemed slightly smoother, but I didn't drive it hard. Yesterday...
After the Jesels, I'll use the SCT Flash Tool, with Dan tuning. I'll probably wait at least a few months as new options and upgrades become available. By next spring the SCT should be a great choice.
SS
Hi Purdue,
Yes, I'll be there to watch. Dan lives in Buffalo, I'm in Toronto. It's a 90 minute drive - but the lineup at the border varies from 10 minutes to 1 1/2 hours. It's always worth the trip - Dan won't do anything without checking with me, always answers questions, and gets the finicky...
Yes, first time. Dan Lesser ([email protected] on this board) is doing the job. He's one of only 3 I let touch the Viper. He's a good cat, you may know him from www.ViperSpecialtyPerformance.com. He swears by the Jesels if you're doing rockers.
SS
Hi guys, got the info: The Crowers that failed were NOT shaft mounted. At the time (2006) they were advertised for use in the Viper. After the failure, shaft mounted Crower rockers were re-installed, and there's been no problems since. Let's hope so. Interestingly, the tech mentioned that the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.