Recent content by v10sloboy

  1. V

    94 gen1 in for sale section with roe blower and much more

    Look in the 94 rt10 section. I think im going to take a break from the viper for now but not for ever. Thanks John Lomant :2tu:
  2. V

    Spring Cleaning/Garage Sale

    How much for the halfshafts, I could use a set?
  3. V

    3.08 to 3.55 what does it cost you on a dyno?

    I have 3.55 gears and I am taking them out because my car is going to make over 700rwhp. At 565rwhp right now it is still not that great, traction limited with drag radials. I think 3.07 is best with boost and 3.55 gears for all motor and close to stock.
  4. V

    What are Stock Pushrods worth?

    0$
  5. V

    WTB: 18" Forgeline VR1's

    Re: WTB: 18 ttt
  6. V

    Another "I love JonB" post. + he may have saved my life (saftey related)

    Re: Another \"I love JonB\" post. + he may have saved my life (saftey related) Good luck with that thing on thursday hope the belt stays on this time.
  7. V

    Help! Rust on brand new rotors?!

    Re: Help! Rust on brand new rotors?! rust is normal
  8. V

    Anyone have a step by step instruction for replacing springs?

    You can adjust rebound by twisting the shock after the spring is off.
  9. V

    Tips for doing a clutch....got any

    I use a plug off of a g35 auto trans fits perfect. Make sure when you tighten the trans to do it evenly. Also do not have the flywheel resurfaced, just scuff it up. Take the shift knob off first before you lift the car up. The trans comes out without the bellhouseing. Take the bellhouseing out...
  10. V

    Water Methanol Update/Issues

    I run 50/50 water ****. I can say that you must be accurate in the mix. I had a batch that was not correct mixture and my car started detonating.
  11. V

    Those with a Roe Blower and the New Vec II Programming - Report In

    My car runs great JD updated my gen1. I use to run rich on #10 now the plug looks better. My tune did not change at all
  12. V

    purner 505a

    $2000
  13. V

    Wanted: Gen I stock exhaust

    I would run high flow cats and stock exhaust that would give you the power and cut the noise
  14. V

    Has anyone had a slave cylinder break?

    I found ou t what happened today the pilot bearing blew apart and caused the shaft in the tranny to wobble at high rpm and broke the slave cylinder.
  15. V

    Has anyone had a slave cylinder break?

    Thanks for the info. I will contact dodge monday. Ill post on the reason and where it is cracked later on. Im going to pull it out this morning. By the way the slave cylinder is inside the tranny. It pushs on the throw out bearing from behind it. I just wish the design was a little better. I...
See more

Latest posts

Staff online

Members online

Total: 670 (members: 9, guests: 661)

Forum statistics

Threads
153,843
Posts
1,686,699
Members
18,455
Latest member
Mando9595

Share this page

Top