Search results

  1. J

    B&M Ripper Shifter Install and Finish Questions

    I simply put the sealant on both sides of the plastic gasket and pressed it against the bottom of the shifter (to hold it there), then worked the shifter up through the rubber boot (I applied some silicone lube to the shaft to help it slide in :o ). Just be sure to get the shifter fork inserted...
  2. J

    B&M Ripper Shifter Install and Finish Questions

    Roadkill has the right approach. I just installed mine a couple of weeks ago from underneath and it was a piece of cake. Just remove shifter handle from inside the car, then from below remove the pan, the two bolts holding the brace for the rear of the trans and lower the trans a couple of...
  3. J

    Heffner Airbox on E-Bay, Looks like a good deal

    Anyone know if this will work with the VIPAIR? ;)
  4. J

    Please read and make suggestions re my tranny rebuild options

    Sure, I can fix ANYTHING, I just want to screw it up the first time on your car before I try it on mine. ;) And of course you would have to sign an agreement never to sue me! As far as "mooch" goes.......you wouldn't be because I'd give you a smokin deal for the install. $449.99 verses the...
  5. J

    Please read and make suggestions re my tranny rebuild options

    Hey Michael, do you know what is damaged in your transmission? Perhaps it would be an option to fix it instead of replacing it? I have a T-56 repair manual in .pdf format around here somewhere (I think it's at work) if your interested in looking at it I could send it to you. Good luck and...
  6. J

    Need a set of clear fog light lenses

    Donzi are you asking for the fog lamp assembly or the covers?
  7. J

    When the old guys say rear end clunk is normal - don't listen

    Re: When the old guys say rear end clunk is normal - don\'t listen Hey Michael, glad to hear you got the u-joint problem fixed. :2tu: How do you like the new rear calipers?
  8. J

    Should I Lead Him On???

    Here we go again, what a deal $20,100.00!!!!! :eek: http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=7938691092&category=66486
  9. J

    WOO HOO! Finally - first race, and it was a great one!

    Hey Phoenix, was it a yellow 996? If so, I'd bet it was Guilly (Supra on this board). It puts out around 500hp I think and TT. We got together for a cruise last week and there was a supercharged Pantera there that way cool as well as other hot cars . :2tu:
  10. J

    Should I Lead Him On???

    I saw this same item about a week ago listed under Viper Parts & Accessories......then it mysteriously disapeared. Somethings definitely not right.
  11. J

    Do you think I can live with 700RWHP ?

    I feel your pain! I've been wanting more HP, but can't decide between all of the options such as........ supercharger, TT, nitrous, heads & cam. Every time I think I have decided which way to go, I second guess myself. :confused:
  12. J

    Elite Air Box

    Chuck is on the right track. I'm currently developing a liquid nitrogen injection system similiar to his AC mod. 200 hp easy! ;) My system will cost $1,000.00, but if you send me $3,000.00 cash I'll send you back a cashier's check for $5,000.00 plus the kit!!!!
  13. J

    The smart way to lift...........

    Here's my solution....less than 3k.... :2tu: http://vca2.viperclub.org/forums/showflat.php?Cat=&Board=UBB14&Number=430994&Forum=All_Forums&Words=&Match=Entire%20Phrase&Searchpage=0&Limit=25&Old=6months&Main=430994&Search=true#Post430994
  14. J

    Whats going on in the car forums today? wicked funny

    McLaren F1 forum - - -Some punk kid in a F16 tried to race me. Now that is funny!!!!!!!!
  15. J

    I think I found a C-6 embryo!!!!

    I found this in the engine compartment near the HVAC housing. Anyone know what it is???........maybe I just picked it up from driving.
  16. J

    9-11-01 Tribute. Not viper related, but very American - Video

    Thanks Todd. Here's a link to another good one..............I especially like the last two minutes. http://vca2.viperclub.org/forums/showflat.php?Cat=&Board=UBB17&Number=430829&page=4&view=collapsed&sb=5&o=&fpart=1
  17. J

    UNSOLVED MIStery. For those who want a challenge, I need major help.

    I'm new at tuning A/F ratios, so this is just a thought and probably wrong, but here goes.....Try adjusting your short and long term trims so that they are closer to 0 (+10 to -10 total). Since your running so rich in closed loop, maybe it is affecting open loop (or higher rpm settings)...
  18. J

    Looking for a good air fuel ratio gauge

    I have the LM-1 and rpm converter from Innovate http://www.innovatemotorsports.com and am completely happy with it's performance and logging capabilities.
  19. J

    Where do you go to change your oil?

    Hey Hockey, if you don't mind driving to south Chandler, I'd be more than happy to change your oil/filter. Check out this thread, my garage is ready...
  20. J

    Ok, My Turn at Showing Off My Dream Garage

    Thanks for all the great comments, it was alot of work. Frank, Actually it is Model SP-7 not SP-7x. I'm not sure what the difference is though. Harbor Freight had the best price, but I think BendPak now only offers the SP-7x model. Viperfreak, No need to worry about the wify hitting the...
  21. J

    Ok, My Turn at Showing Off My Dream Garage

    My BendPak 7000 lb. scissor lift. I had a buddy with a walk behind concrete saw cut out part of the slab. Then using a sledge hammer I excavated the concrete and some of the AB, then poured some concrete to make it level with the pads of the lift. I can lift it all the way up with about 6 inches...
  22. J

    Selling out !! Viper parts for sale !!

    Re: Selling out !! Viper parts for sale !! PRICES !!!!!!!!!! Jon, I sent you an email. Ill take the B&M shifter. Jim
  23. J

    I got a silver SRT10 Ram ............

    I heard those hoods add 16RWHP but it feels more like 50. :p Sorry, I couldn't resist. Your truck looks great.
  24. J

    VETTE BEING PUT TO THE RIGHT USE

    Thanks hockey, you just made me spray beer all over my keyboard via my nose! ;)
  25. J

    Paint code for Viper Race Yellow?

    Janni, I believe it is PYR. Jim

Latest posts

Members online

Total: 1,041 (members: 10, guests: 1,031)

Forum statistics

Threads
153,839
Posts
1,686,669
Members
18,448
Latest member
JpKL

Share this page

Top