Search results

  1. V

    96 Twin Turbo Photo Shoot

    Nice pics!! Is ist expesnive to get this type of photos done on a car?
  2. V

    WTB 96 or 97 GTS

    What are you up to now Mike? Julio
  3. V

    Playing at the 1/4 mile this past Saturday

    Tony, is that pump gas and meth? How much timing are you running in the upper rpms range?
  4. V

    AC blowing thru winshield vents after high boost pull

    No check valve here. How can I access the actuator and/or the line connecting to it thru the fire wall? Is there access to it by removing either the driver or passenger under the dash panels?, or is a complete dash removal necessary? thanks!
  5. V

    AC blowing thru winshield vents after high boost pull

    This is the line I'm talking about. (not my car, but this is the line) A/C Vacuum Canister Kit 96-02
  6. V

    AC blowing thru winshield vents after high boost pull

    I looked a that vac. line. It is on the passenger's side intake plenum in the right rear corner. The hose was attached to the plenum. I followed its routing and it goes into the fire wall more or less at the center of the motor. I disconnected it from the plenum and blew with my mouth thru it...
  7. V

    AC blowing thru winshield vents after high boost pull

    Guys, A/C was working fine and blowing air thru the front vents. After a high boost pull it started blowing the air thru the vents in the rear of the dash by the bottom of the front winshield (defronst) No matter in what position I put the switch in the console it blows the air in the same...
  8. V

    Low Voltage. AEM culprit?

    The voltage regulator is inside the AEM.
  9. V

    MIKE BRITO has Tuned my TT VIPER to perfection!

    AEM, wtih injector driver and 152 lb. injectors. Iddles at 700 rpms with no searching at all, steady as a rock!
  10. V

    MIKE BRITO has Tuned my TT VIPER to perfection!

    Here are some pics. The fabriction was not done by Mike. It was done by a local guy who is a good friend of mine. The welds do not look that clean, but the sytems works, and no cracks so far in any of the welds. I wish Mike had done the fab. work, but we had not met when I had my system done...
  11. V

    MIKE BRITO has Tuned my TT VIPER to perfection!

    Not sure if he does travel, contact him and ask. I'm lucky that he is 40 miles away from home. Turbos are 76 GTSs with .96 ARs. Waste Gates are plumbed into the exhaust, not dumped.
  12. V

    MIKE BRITO has Tuned my TT VIPER to perfection!

    What a long road it has been with the tuning chapter of this car. I can finally say that my goal has been achieved and the responsible person that has made this happen has been Michael Brito from Brito Speed.:D http://www.britospeed.com/ After being around for a while I have gotten to know most...
  13. V

    Today's Standing Mile Results for My SRTC

    Get John Donato to do the .80/.63 gear ratio swap for 5th and 6th. Perfet for the mile! only 1200 rpms drop from 5th gear to 4th gear, and if you have the power to go over 200mph, the drop between 5th and 6th is also 1200 rpms. This is based on a 6,000 rpm shift point.
  14. V

    Soft Paint for 97 GTS dash

    Found some vinyl paint to touch up my black dash around the speedometer. The color matches, but the base of the vinyl paint is enamel. Whenever the enamel comes in contact with the stock paint it acts as a paint remover, and the stock paints peels off more. Needles to say, what started out as...
  15. V

    Alingment specs needed

    thanks for the info!
  16. V

    Degreeing the cam and margin for error?

    I don't think you can change degree on the cam with the stock timing chain, as it does not have any adjustment. My stock Intake Center line was at 118 deg.
  17. V

    Alingment specs needed

    I do a few 60-160 pulls on empty roads once in a while.. Recently changed tires height ,removed the Eibachs and put the lowering caps. I would like to get an alingment done on the car as I'm sure the suspension geometry has changed some. What do you recommend for street driving with good...
  18. V

    Part number Needed

    got it! 53020419
  19. V

    Part number Needed

    Guys, does anybody know the part number for the Spark plug wires heat shields? These are the metal cylindrical tubes that go around the park plugs to protect the wires boot. They are attached to the cylinder heads. TIA.! JC
  20. V

    Steering Column GAUGE POD

    Are they still available, where can I get one? thanks!
  21. V

    PICS – Went Twin Turbo

    Simms, can you post a pic of your gages layout? thanks!
  22. V

    PICS – Went Twin Turbo

    Simms, I like the look without the fog lights, how did you go about doing that?
  23. V

    PICS – Went Twin Turbo

    Simms, looks really nice!!! Show us some pics of the underneath to see the "meat" of the build!! thanks!
  24. V

    ACR in the Florida 1 Mile Event...

    I was there with a group fo guys at the 3/4 mile marker, one guy had a radar gun. I remember your car in the 170s. ZR1s were going low 180s. A friend of mine with 530 rwhp "old" 90 ZR1 did 181mph. I would think a Viper with 600+ rwhp would be in the 180s also... Did you see the TT GT that run...
  25. V

    My AR Fabrication 540ci stroker motor

    final numbers?

Latest posts

Members online

Total: 1,245 (members: 7, guests: 1,238)

Forum statistics

Threads
153,839
Posts
1,686,670
Members
18,450
Latest member
Bcanfield

Share this page

Top