Canyon707
Enthusiast
Well I actually couldn't beleive that the Viper Mag would put in a story about this product. I have posted many many articles about the poor quality of this product and it's is still at the factory as a recall. The story goes jsut like this. Andrew in Texas had one and had problems getting it to Idle below 1500 rpm. He sent it to me to try out and I had the same issues even trying to adjust the TB sensor. I wrote to the factory since they don't list a phone number on ther web page. Anyway I ended up sending it back to them and a few day later I got it back. It idled down around 750 ( not bad) but, this time the throttle blades were rubbing on the body making the throttle stick shut make it hard to take of from a stop sigh etc. I took it back off and put it to the light I could see the butterflies rubbing over 50% on one side and some on the other side. I contacted BBK about this issue and they were aware of it and were making adjustments and were going to send out a new one once they resolved the issue. That was a couple months ago still nothing. My issue here is that X-Metal single blade TB has no issues that I am aware of it's near as perfect as you can get it totally polished works perfect. The HP increase probably is minimal on either one but I think before you write an article about something like this it should be looked at by more than the author of the article. Very Disappointed.
