GTS Dean's latest activity
-
GTS Dean reacted to daveg's post in the thread new to me 2000 GTS overheating within minutes. with
Like.
None of the Pics you showed indicated the Motor was running at that temp. Shoot at the base of the thermostat housing. -
GTS Dean replied to the thread new to me 2000 GTS overheating within minutes..I put a new NAPA t-stat in my car a few years ago and it had a bleed orifice already installed. It allows for efficient cold fill...
-
-
GTS Dean reacted to ISMarco's post in the thread Loose harmonic balancer AND crank pulley with Like.
Good catch! The pulley bolt torque spec is super high, ~250 ft*lb. But unfortunately they still come loose. I feel like this problem...
-
Clogged/bad catalytic converter. Maybe $7k with used parts. G3 hoods are plentiful and cheap, $500? Sill and fender $3k Hopefully...
-
Correct. Do you have a Service Manual? I am selling one. It spells it out nicely, but not hard. After getting all(hidden ones too), it...
-
GTS Dean replied to the thread Aftermarket Proportioning Valve Install Question.Both circuits get full pressure for the initial application. Above a certain relief pressure, the rears build proportionately less than...
-
GTS Dean replied to the thread Another crank no start thread but with a twist.Yes, it's the one from the cross-brace area connector to the cam sensor.
-
https://youtube.com/shorts/9r88nOMvRAw?si=xt5YKtmQPvOLeCuH Here is a link to how Blucifer did in the Celebration Exotic Car Show
-
GTS Dean replied to the thread Aftermarket Proportioning Valve Install Question.It happens to be the Right and Only way to plumb the adjustable valve in. You MUST disable the OE proportioning section. Or, put a new...
-
GTS Dean replied to the thread Another crank no start thread but with a twist.I had cam sensor checksum errors. Swapped in a spare and had the same problems. Turned out to be a bad wire in the cam lead.
-
GTS Dean replied to the thread The Quest for 275 MPH.Temp and air density will be what you tune to with the spoilers.
-
GTS Dean reacted to BoondocSaint's post in the thread speedometer calibration box instructions with Like.
It does look very similar to the paperwork that I have for mine...well, the one I haven't gotten around to installing anyway. I'm sure...
-
I bought a bunch of Viper parts and was going through the boxes. I found this very detailed document and determined it was from Unitrax...
-
GTS Dean reacted to dipietro9006's post in the thread Loose harmonic balancer AND crank pulley with Like.
Just wanted to share my recent experience. A few drives ago, I noticed my belt was squeaking. I figured it was an idler pulley. Upon...
-
Victory is mine! I ran a 2ga wire from the alternator to a 150 amp mega fuse, then to the starter stud. Upsized the alternator ground...
Latest posts
-
Want to ID this brake duct part that was vendor made- Latest: Tom and Vipers
-
-
-
-
-
-
