Recent content by repiv1

  1. repiv1

    Borla catback

    I wish I would have chatted with you guys before my purchase. For now it is on to stay. It is not a bad system just not aggressive enough, I was hoping to make a little noise.
  2. repiv1

    Borla catback

    I just hijacked a post to give you their thoughts on the Borla system. The last two sentences are pretty much my thoughts from what I had read. "I finally received my Borla exhaust, which as some of you may know, was a hassle in itself. Buy anyways, it arrived yesterday and I couldn't have been...
  3. repiv1

    Borla catback

    If I were to describe what it sounds like now, it is smoother, lower pitch, and much quieter. After reading so many complaints about the Borla system being ridiculously loud, I was apprehensive to order their system. Right now it sounds more like a Cadillac than a Viper. :drive:
  4. repiv1

    Borla catback

    Ha!
  5. repiv1

    Borla catback

    Just installed a Borla catback system on my 08 Viper with 15,000 miles.It is not only quieter than my stock system it is significantly more quiet. Is there a breakend period for the system?
  6. repiv1

    What plugs do you recomend?

    Thanks for chiming in with the info. It sounds like stock is the way to go! I really appreciate the support from you guys, thanks! Rory
  7. repiv1

    What plugs do you recomend?

    Hey Guys Time to change my plugs and I am looking for recomendations for my 2000 R/T 10 with Belanger cat back system. I have new wires on the way as well. Thanks in advance for your advise! Rory :2tu:
  8. repiv1

    Code

    Just and update for those who care. I had the cam sensor replaced by my mechanic and it seemed to do the trick. Cost was $137.00 for the part and repair so depending on your mechanic or your skills it is not to bad to replace. Anyway left the mechanic shop gettin sideways with a huge smile on my...
  9. repiv1

    Code

    Thanks everyone for the helpful info. I will look into both sensors tomorrow and have them both replaced. I really appreciate the calls that I received earlier today from dave6666 and fatboy18. You folks me proud to be affiliated with the Viper club. Rory 510-569-2611
  10. repiv1

    Code

    I just pulled the code on my 2000 Viper R/T 10 and it read P1391. Can anybody give me some guidance on what I should be looking for. The only mods are a cat back exhaust system. One other note is that is seems to be running fine now but the check engine light is on. Originally it would backfire...
  11. repiv1

    Check engine light

    Thanks guys for all the info....it is well appreciated!
  12. repiv1

    Backfires then dies.

    Just happened yesterday and I don't have a code reader so I am not sure about that.My brother is on the way with code reader. The only upgrade is Belanger exhaust and K&N Filters. 52000 miles. Thanks for your response!
  13. repiv1

    Backfires then dies.

    Hey guys I was hoping someone could tell me whats going on with my 2000 RT/10. I was pulling into my driveway yesterday and while idling it gave a small backfire then it died. Started up no problem but again the same thing, backfires then dies.Check engine light is now on as well! Anybody...
  14. repiv1

    Check engine light

    I was pulling into my driveway today and before I could pull in with the car idling it made a small backfire and then died. started right back up but again at idle it backfired and died. Does anyone have a clue as to what I should be looking for? 2000 RT/10 53,000 miles. Rory :curse...
See more

Latest posts

Members online

Total: 674 (members: 7, guests: 667)

Forum statistics

Threads
153,189
Posts
1,681,847
Members
17,684
Latest member
Liberty235

Share this page

Top