Search results

  1. V

    Gen I exhaust suggestions needed

    Don't forget that dynomax makes a great sounding muffler for about $55 a side in 3in. inside diameter. These are the straight through design and sound an awful lot like the old chambered mussle car exhaust of the late 60's early 70's. They have them in summit listed as dynomax Race bullits. Also...
  2. V

    Why is it that 4 bangers can run 19psi of boost and vipers not

    O.K. just to straighten out the boost issues for you. 1. boost is not hard on rods and cranks(to an extent) 2.Big motors can run big boost( I have a big block chevy 496 cu.in. with a T-100 that regularly sees 25 psi, with stock rods and crank, good pistons) 3.The valve design only helps...
  3. V

    CM Perf. TT Viper -722whp/772wtq at 8.5 psi

    Davem, we have any high boost 4-digit dyno runs yet? Just checking in. Drew
  4. V

    What amount of nitrous is safe on an 01'

    Re: What amount of nitrous is safe on an 01\' HP, what do you usually try to run consistently 140 propane/900nitrous,150propane/1000nitrous, 160propane/1100nitrous. Just curious what is the best correlation of the two? BigCarrot, Keep us updated LOL ;) :D
  5. V

    What amount of nitrous is safe on an 01'

    Re: What amount of nitrous is safe on an 01\' Thanks again Tom. I will make a mental note as I don't want to be the one to figure out exactly what it takes to pop an 01' ;)
  6. V

    What amount of nitrous is safe on an 01'

    Re: What amount of nitrous is safe on an 01\' Mr. Welch, Thank you so much for that information. That is pretty much what I had in mind. I plan to tune my car on a dyno equiped with a motec WBO2 so there shouldn't be any issues [knock on wood]. I had planned to run in the 11.0 to 11.5 A/F...
  7. V

    I think that we should have FS and WTB section

    I am up for that. Same goes for parts. I would also like to see a tech section that is divided up into say Nitrous tech, Forced induction tech, and of course regular Gen 1 and 2 tech. Just my $.02 Drew
  8. V

    What amount of nitrous is safe on an 01'

    Re: What amount of nitrous is safe on an 01\' Dan, I appreciate the offer. However, I already have the NX wet kit from my C5 and I have bought most of the other parts to make it work with propane instead of gas for fuel enrichment. Thanks for your offer though. Drew
  9. V

    What amount of nitrous is safe on an 01'

    Re: What amount of nitrous is safe on an 01\' Mr. Welch, thank you so much for your final answer. I appreciate that very much. Sorry if I came off as an *sshole. I just got a little impatient, thats all. If I could possibly receive one bit of FREEBIE information from you, It would make me very...
  10. V

    What amount of nitrous is safe on an 01'

    Re: What amount of nitrous is safe on an 01\' J, so true buddy. I was hoping someone had already been down that road and took notes. LOL I was hoping a 200 or 250 shot would be safe. I do know that just the slightest bit of detonation and a 350 shot tends to put the rings in the oil pan on a...
  11. V

    What amount of nitrous is safe on an 01'

    Re: What amount of nitrous is safe on an 01\' Tom, First off I very politely said that I realized you were a very busy man and completely understood you not immediately returning my E-MAILS. I did not leave you a message on your answering machine as I assumed the e-mails were enough and didn't...
  12. V

    What amount of nitrous is safe on an 01'

    Re: What amount of nitrous is safe on an 01\' Thanks for all of your help so far guys this is exactly what I was looking for. Trent I will PM you right now.One question why are you two guys so far apart on jet sizing. When comparing the two HP's version seems dangerously lean and trents seem...
  13. V

    What amount of nitrous is safe on an 01'

    What amount of nitrous is safe on an 01\' I was planning on running the nitrous/propane setup as well as eliminating the cats so I can run race gas when spraying for an extra level of protection against detonation. The car is a 2001 RT/10 with a 3in. corsa catback, high flows, smooth tubes, and...
  14. V

    CM Perf. TT Viper -722whp/772wtq at 8.5 psi

    Dave, I understand completely. That seems to be everyones goal these days, 4digits :D And you guys are well on your way no doubt. I was just making a statement for your street drivin kits. Good luck and keep us posted on the dyno and track times. Should be very impressive. Drew ;)
  15. V

    CM Perf. TT Viper -722whp/772wtq at 8.5 psi

    Very impressive to say the least. However, from my past experience with several turbo cars (buick GN's, Supras, And even some custom stuff we've done) It appears the turbine housing A/R is just slightly to large. I would probably try a .81 or .96 just for reference. I am not by any means trying...
  16. V

    VIPER OWNERS UNDER 30

    Yep, definently helps to know your agent. I am an insurance agent. 23 by the way. However, we also own a used car lot and I run dealor tags on the viper. Just cheaper that way. ;)
  17. V

    This didn't happen to me last year.........Please help.

    Re: This didn\'t happen to me last year.........Please help. Yep, to rich. Black smoke is fuel. Nothing to worry about. Worry about blue or greyish white smoke. If it really bothers you you could buy an Apexi AFC, but I personally don't like them. Had one in my supra and it was junk. Just my...
  18. V

    insurance question for 01 viper

    I am personally an insurance sales rep and I will go ahead and tell you now that You should shop around and get each company to quote you with all of your insurance needs (home,all cars, life, ect..) as Bruce said. However, unless your ticket is over 3 years old, 5 to some companies don't forget...
  19. V

    Problems with Nitrous on a 2001

    Yeah, I know I can call them, and I plan to, But I wanted to hear some opinions from you guys as well. Thanks again, Drew
  20. V

    Problems with Nitrous on a 2001

    Okay, guys I am a newbie to the viper community. I was wondering what you are actually able to run on a 2001 RT/10 without hurting hardparts. Car already has corsa catback, smooth tubes, and K&N's. Would it be safe to use a 200 shot. Planning on removing the converters so I could run race...
Top