So, I was using a test light on my Viper. I was trying to see if my fuel selonoid was getting power when the throttle switch was engaged. I connected one end of my test light to ground and then probed the hot wire on the noid. When i engaged the switch the fuse immediately blew. I put in another...
Anyone know anything about a biger ROE? I'm not sure what size the standard ROE is but I read at the alley about a "new" 2.6L ROE. Also, anyone have a 10 pound pulley for sale?
Thanx
One,
Recently my speedo starting jumping all over the place when I drive. Car is a 97' GTS. I can be doing 30 and it will bounce around from 40 to 130. Have had a re-cal box on for two years becuase of my 3.55's. Does it sound like the box took a dump?
Two,
Every once and a while my...
So, I drove my car last week and it ran perfect. Washed it before going home at a coin wash. I have done this same thing for two years. I go to drive my car today (week after washing) and it had a slight "machine gun" kind of sound to it. Just wasn't right. I went to see if a different card...
I don't post much but I just had to tell about my Performance by Joe experience. I have a 97 GTS. The car already had a set of bowl blended heads, stock valve sizes, mild cam, nitrous and the other usual bolt-ons: VEC 2, headers, cat back, rockers. Car ran pretty good NA. Made 520/540 on it's...
Drove my 97' GTS today. Ran great. Got home and realized I had a check engine light. Pulled the code it was a cam position sensor bank 1 fault. Cleared the code and went to start the car and nothing. Spins over fine, just seems like no spark. Checked for fuel pressure - plenty. Code...
I just hooked up a boost guage on my GTS. I spliced into the line going to the Vec2 for the vacum/boost signal to the map sensor for the guage (electric guage). Reads boost great, but at idle I get a zero reading for vacum. Steady cruise vacum reads ok but not at idle. Also, there only...
Just recently my car has developed a "shuddering, popping" noise when making left hand turns from a stop. Only happens when making the turn from a stop to the left. Does not have to be a very sharp turn. The noise comes from the outside (passanger side) rear. I am thinking either the u-joints...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.