94 RT/10 Hard to start, clutch switch replaced, still no good...any ideas??

[scottgf]

Some times my 94 RT/10 is hard to start, I have to push the clutch pedal down VERY HARD to get the starter going. I replaced the clutch switch but it didnt seem to help. The clutch pedal feels ok, (not loose or anything).
This is kinda embarassing when the valet has to come get me because he cant get my baby to start. Any ideas on how to solve this problem. (The floor mat is not the problem)
Thanks in advance,
scottgf

 

[Newport Viper]

Just had the same problem. It was the clutch switch. Maybe you got bad switch??? Call David Jenkins in Socal, Neighborhood Chyrsler service Irvine Center Drive

 

[Sean Roe]

I would use a "quick tap" and connect the two wires that run down to the switch at the clutch master cylinder and try starting the car without pressing the clutch. If it starts fine, you have a bad switch or something else is out of spec not allowing it to make contact soon enough. You can leave the quick tap in, or wire in an on-off switch. Just remember to make sure its in neutral when you start.

Happy Holidays,