Clutch Recommendation

[MiamiSpd]

I am presently running a Center Force clutch. Clutch was installed and went straight to the dyno. No break in time. Third and fourth gear shifts at WOT have become very difficult. Shifting at part throttle is fine. The problem is at WOT. I am pretty sure that the problem is the clutch.

I have been recommended the Spec Stage 3+. I do not have any experience with this clutch. Looking for some feedback.

BTW, I still will be using a stock flywheel.

Recommendations are appreciated.


Jorge

 

[MIKE-HKS]

jorge, here's an idea , check to see if the pressure plate is opening up all the way , you might need to install a shim infront of the pump ,to get the plate to release completely

 

[Joseph Dell]

or bleed the clutch slave cyl.

JD

 

[Schulmann]

Myself, I have Center Force clutch and it runs perfectly.
From the shifting it is difficult to say what type of clutch I have.

There is always a little break-in periode for a clutch ... drive at least 20-50mi in city so you shift a couple of times.


As Joseph advised start by bleeding the clutch slave cylinder. Then no matter what you will have to remove the transmission.