RC Viper
Enthusiast
I am trying to install the Northwind Engineering 2 inch seat lowering kit on the drivers side seat. I previously had the 1 inch lowering kit in the car. I have installed the brackets and can place the seat in the car. All four points line up (2 holes in the front of the seat and two studs to the rear). I can even put the bolts in the front holes! Now the question. How in the world do you put the nuts on the back two studs? There must be a trick!!! I can barely get my hand between the seat cushions. Let alone put the nut on the stud and tighten it. I know many people on the board have accomplished this install. How did you do it?