No low beams

[Bill W]

I had an evap purge solenoid installed at the shop, and the next day I discovered I have no low beams. High beams and fog lights work. Is it possible that the mechanic might have dislodged a wire while he was working under the car installing the new part, or is that unlikely?

 

[Goggles Pizano]

Lo and hi beam have different relays and fuses.

 

[Goggles Pizano]

The solenoid is on a different circuit but same main connector to the PDC but different splice.

 

[Bill W]

I pulled both low beam fuses, and they looked ok. I put two new fuses in, turned on the switch, and the lights came on!

 

[Goggles Pizano]

Check the old fuses with a meter and Magnifying glass.

Also use little pick or screwdriver and see if the filament asca break somewhere