Clown Shoe
Enthusiast
Does any one know what the correct measurements are for putting the front side emblems on a 95 R10?
side emblems
- Thread starter Clown Shoe
- Start date
Clown Shoe
Enthusiast
Come on guys stop being so lazy and go out to your garage and measure for me. PLEASE
I'd say have a little patience. 1/2 hour on a Sunday night is a little fast, especially when you are expecting someone to go measure their car. Most in the north have them covered and put to bed.
If no one else responds soon I will get the manual and take a look. First task will be to locate the body manual. I haven't seen it in years.
If no one else responds soon I will get the manual and take a look. First task will be to locate the body manual. I haven't seen it in years.
Clown Shoe
Enthusiast
Thanks Ron Ghetto
99 R/T 10
Enthusiast
Does it depend on the year? How about if the workers that day had a few too many the night prior?
carguy07
Viper Owner
Looks like about 8 1/4 from bottom edge of the hood to the top of the emblem.
Left side is 3" from back of wheel well. Right is like 3 1/2.
Just go up 8 1/4 and eyeball the side to side. I would bet they measure all over the place from car to car. IMO.
Left side is 3" from back of wheel well. Right is like 3 1/2.
Just go up 8 1/4 and eyeball the side to side. I would bet they measure all over the place from car to car. IMO.
Clown Shoe
Enthusiast
Thxs Carguy, what does IMO mean? Ghetto
ROCKET62
Has Left the Room!
CARGUY is about right on!
According to my '93 service manual it is 8.2" (205mm) from the bottom of the hood to the top of the emblem. The V in Viper starts 3.8" (95mm) from the wheel well (at that same 8.2" level.)
Good Luck!
According to my '93 service manual it is 8.2" (205mm) from the bottom of the hood to the top of the emblem. The V in Viper starts 3.8" (95mm) from the wheel well (at that same 8.2" level.)
Good Luck!
carguy07
Viper Owner
In my opinion
GCHDEALER
Enthusiast
Ask Adam 96 he may help you..
Clown Shoe
Enthusiast
I tried lol
