What are you guys using for clutches?

[carl B]

I am involved with building a high BHP motor right now

I am going to run a Roe Blower with 10 psi pulley. Greg Good heads Weldon pump Etc

What clutch will I need with my aluminum flywheel??

Carl

 

[STUGOTS]

I asked the same question to Sean Roe and the response was centerforce

 

[Shelby3]

There's guys with high end Roe setups and nitrous running stock clutches at the V10 Nats and doing just fine.

 

[FlyBryViper]

I was going to say...my left leg...

 

[STUGOTS]

I was going to say...my left leg...

LMAO


its like the joke where you ask someone ............ which hand do you wipe your a$$ with?? and when the say right or left you reply "really I use toilet paper you sickj F*CK". lol

 

[VIPR GTS]

the LUK (stock clutch) seems to hold pretty high HP well so far

 

[BigCarrot]

I have a Spec clutch in mine.

 

[VPRTKMIKE]

I have seen 1000+hp cars with stock clutch and aluminum flywheels, still holding up for 2 years now.

 

[cgmaster]

I am using a Tilton 7.5" Carbon carbon clutch now. It is the lightest with the lowest moi and you can modulate it. I will have to look for the specs but I think the clutch and flywheel came in under 10 lbs. The only problem with it is cost. I think the stock clutch will hold plenty of torque and last a while but it also is over 60 lbs of rotating weight. Just my 2 cents.

 

[Cop Magnet]

Just bought a new LUK on eBay for $175. Only have 15000 miles on my car but since the trans was coming out under warranty, thought it would be stupid not to replace it for that kind of money.

 

[carl B]

OK thanks guys


carl