Frankster
Enthusiast
Was doing a finishing hone on one of the cylinder sleeves and noticed it had moved out about 1/4 inch.
Was able to get it back into place with a plastic mallet.
Now I'm worried about an internal water leak when it's all back together.
Should I be worrying?
Does the sleeve have water flowing around it and if so how do I seal the sleeves?
Was able to get it back into place with a plastic mallet.
Now I'm worried about an internal water leak when it's all back together.
Should I be worrying?
Does the sleeve have water flowing around it and if so how do I seal the sleeves?