Recent content by mntngts99

  1. M

    Any msd boost a pump install photos

    I pulled the carpet off the rear deck. There is a round access cover on top that I removed to fish the wires up to the fuel pump and wired it direct.
  2. M

    Dyno Nitrous Results...very disappointed

    I would get six passes on a ten pound bottle. I used a 42 nos / 25 fuel and made 607 rwhp and 700+ rwtq at 1100 psi on the bottle at 11.4 AFR.
  3. M

    Clutch time

    Man I'm sorry guys. I was just looking for some more info on clutches for slightly modified cars. I think the information here fits in with all the others I've read. Stock- Is a good clutch but falls short Others - nobody cares for
  4. M

    Clutch time

    Dave. I can get 1.6x 60' times on pilots and 1.4x on BFG D/R's . I think I can drive
  5. M

    Clutch time

    Alan last time we talk I thought you were going with a ROE. Good to hear you stepped up to the TT
  6. M

    Clutch time

    Now y-all can see my dilemma. data supports trying stock clutch one more time. Votes so far stock 2 Spec 0 Centerforce 0
  7. M

    Clutch time

    What series on the RPS did you go with ?
  8. M

    Clutch time

    I thought you had a Spec 3+
  9. M

    Clutch time

    I have used the Search. I'm on my second stock clutch, didn't last a year, 661 rwhp 697 rwtq . Try stock one more time or go with Centerforce or Spec ???? TIA
  10. M

    Motor question

    Thanks Chuck
  11. M

    Motor question

    I can visible see the drivers side is about 1/2 inch higher then the passengers side. I put a level on top of my ROE and its defiantly out of level.If I loosen all mounts and level it up I should be ok ?
  12. M

    Motor question

    Can someone tell me if the motor should sit level or slightly lower on the passengers side. Thanks
  13. M

    Roe 8 lb with Water/****

    Is it newer then 1999 and have some T's in it ?? I'll call you tomorrow.
  14. M

    Kennys Viper progress?

    DUDE :buttkick:
  15. M

    Broken Ring Gear Bolt

    When its time to put it back together make sure the carrier bearings are seated all the way into the housing,, DO NOT USE THE BEARING CAPS TO SEAT IT.
See more

Latest posts

Members online

Total: 855 (members: 9, guests: 846)

Forum statistics

Threads
153,198
Posts
1,681,912
Members
17,696
Latest member
Viper123456

Share this page

Top