The US version is a joke. The lines are scripted, the so called comedian stinks, and the challenges are *** as they come.
I DVR'd the first few episodes then couldn't take it anymore.
:usa:
I just carefully and systematically drilled small holes into the existing plate that is there. Not sure if that is fas paux but I dont really care.
Cost 0$
:usa:
Dave has a legitimate question? :omg:
All kidding aside from my experience the starter should still turn the engine over for some time before it totally sh!ts the bed on you. It definitely should have two more starts in it (to get you to/from the shoot).
The local shop guys and dealer...
Re: Can people please post pictures of their GEN II lowered with KW Variant 2 coilove
http://forums.viperclub.org/srt10-srt10-coupe-discussions/643982-pics-kws-installed-finally-slammed.html...
Advance Auto Parts: Ball Bearing by National - Part 614061
Above is likely your culprit. If you order the slave this part is included at a cost of around 260 bucks total / give or take.
Just the bearing is 35-40 bucks at the local parts store.
When you get into it and start tearing it...
Throw out bearing could be wearing/worn out. Pressure plate as said above.
Start with a fluid change and a couple of phone calls then tear into it and start inspecting if you are gonna do the job yourself.
:usa:
Ditto. You don't need near 16oz of shampoo per foam gun application. You waaaay over did it there.
Don't drive the car before you swirl remove or you have to start all over with a wash.
Also consider doing a clay bar before swirl removig since you've prob never done that. Try the sammich...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.