Recent content by RT/ED
-
R
stabilizer link
Anyone know the Moog part number for Gen 1 rear stabilizer links?- RT/ED
- Post #8
- Forum: RT/10 and GTS Discussions
-
R
Winter mod list...
I used the 2.5 inch spiral mufflers. Sorry, the Viper is tucked away for the winter, no sound clip available.- RT/ED
- Post #11
- Forum: RT/10 and GTS Discussions
-
R
Winter mod list...
Consider using the Moroso Spiral Flow stainless mufflers instead of a test pipe. I installed these on my RT/10 in place of the cats. NICE!!!- RT/ED
- Post #4
- Forum: RT/10 and GTS Discussions
-
R
Viper runs hot when sitting in traffic
My 95 was doing the same thing following a coolant change. Burping alone rarely eliminates all of the air in the system. I suspect you still have air in the system. The "Wizard" (Chuck Tator) recommends carefully removing the heater hose connecting the thermostat to the heater control valve...- RT/ED
- Post #19
- Forum: RT/10 and GTS Discussions
-
R
Two Post Lift for long term storage?
Anyone using a two post lift for storing their Viper during winter months? Thinking about adding a two post lift so that it would offer me the versatility of working on tires/brakes/suspension.- RT/ED
- Thread
- Replies: 14
- Forum: RT/10 and GTS Discussions
-
R
Where to get wheels chromed
Yes to California Chrome (CalChrome). Excellent quality and fast service. Reasonable pricing.- RT/ED
- Post #4
- Forum: RT/10 and GTS Discussions
-
R
Supercharged + Belanger + Catless + Borla XR-1, too loud?!
I had Borla Headers and the same Roe exhaust setup on my Gen I (not supercharged), a bit loud and too much drone at highway speed, needed ear plugs on a long trip. I changed to the following: - kept Borla headers - deleted Roe HF cats and replaced with Moroso stainless spiral flow racing...- RT/ED
- Post #4
- Forum: RT/10 and GTS Discussions
-
R
hole in soft top
Iron-on black fabric patch from the underside works well. You can purchase fabric patch on line, fabric stores, etc. Remove the top from the car and open on a flat smooth surface with the interior of the top facing up. Cut a circular piece of the iron-on patch about 1/3 larger than the area...- RT/ED
- Post #2
- Forum: RT/10 and GTS Discussions
-
R
Best Engine Oil for the GTS
I just attended a plant tour of the Penzoil facility in Detroit (River Rouge Blend Plant) with fellow MCVO owners yesterday. The Penzoil folks shared a ton of valuable information. A few pointers worth sharing area as follows: - Penzoil, Shell, Quacker State are all owned by the parent...- RT/ED
- Post #31
- Forum: RT/10 and GTS Discussions
-
R
New Viper (new to me..)
TIRES TIRES TIRES - if the tires are older than 5 years, replace them (top priority). Consider changing all fluids if there are no maintenance records that reflect recent fluid changes (radiator, transmission, differential, brake fluid flush, clutch fluid flush. Several posts on recommend...- RT/ED
- Post #9
- Forum: RT/10 and GTS Discussions
-
R
94 battery replacement
Battery is located in the rear drivers side wheel well. You need to remove the rear drivers side wheel using a jack stand for safety. Then remove the rear portion access panel of the inner fender well, about 5-6 bolts to include the rear fascia bolts and two frame mount bolts. Not a...- RT/ED
- Post #3
- Forum: RT/10 and GTS Discussions
-
R
1995 Power Steering fluid question.
I have been using Valvoline synthetic power steering fluid for years. Use a turkey baster to remove the old fluid from the reservoir and replace with fresh fluid. Repeat this process after you have driven the car for a few miles 2-3 times and you will have replaced the majority of old fluid...- RT/ED
- Post #2
- Forum: RT/10 and GTS Discussions
-
R
Quick Time Bell Housing for T56??
Wondering if anyone has experience with installing a Quick Time (RM-8071) transmission bell housing on a Gen I or Gen II? Are there any fitment issues, driveline changes required, etc? Thank you edrt10- RT/ED
- Thread
- Replies: 1
- Forum: RT/10 and GTS Discussions
-
R
Cars fall into sinkhole at National Corvette Museum
This is a VERY unfortunate event! However, I could not pass up the opportunity to take a dig at my brother who owns a Corvette.....all in brotherly love. I told him they just learned that the sink hole was the result of a Viper Den that was discovered beneath the museum. Still waiting...- RT/ED
- Post #7
- Forum: RT/10 and GTS Discussions
-
R
Hood "grills"
Satin Black is what I have used. Looks like OEM.- RT/ED
- Post #2
- Forum: RT/10 and GTS Discussions
