-TRQuixote-
Enthusiast
Having one installed this week and curious if the stock handle will work (preferred).
Thanks!
Thanks!
B&M With Stock Shifter Handle? (2nd Gen)
- Thread starter -TRQuixote-
- Start date
SHELBYVIPER
Enthusiast
Yes the stock handle will work. Installed a few of the B&M Shifters.
white out
Enthusiast
Get an IPSCO lowering rod, personally for a '97 the 2" lowering is ideal.
OP
OP
-TRQuixote-
Enthusiast
Does that work in conjunction with the B&M? It goes in tomorrow, so Id likely have to add that on myself later if so.
white out
Enthusiast
Yeah, it replaces the stock shifter rod that threads into the B&M shifter. Easy to replace - tell the shop not to crank down on the stock shifter rod when re-installing so swapping it is easier. Swapping it out is super easy - just remove the center console pad & trim and thread it off, then screw on the shorter unit.
Also, tell them to be careful with the rubber boot (not the leather one you see inside the car, below it). It's a NLA part and VERY easy to tear.
Similar threads
Latest posts
-
-
-
-
-
-
Turning gauge cluster plastics back to white- Latest: Viper Specialty
-
-