clutch questions

[Bigviper]

burnt out my standard at the weekend doing a 1/4 mile at santa pod ,low down is replace with standard clutch and fly wheel or go after market? i,m running gts 2002 with a 5lb pullie on a roe blower , around 550 bhp any surgestions??the car had 4000 on it before the blower went on it, and has now done 7000

 

[dave6666]

Stock clutch is fine and only $165 on this side of the pond ebay. Spend more get more I suppose.

 

[mjorgensen Woodhouse]

We have had good luck using the ATC kevlar clutches $525

 

[VIPER BAZ UK]

Is that on the stock Flywheel Mark?????
Need to get this fixed ASAP as its going out in 3 weeks time....

 

[plumcrazy]

yeah mark, anymore info on that clutch ?

 

[mjorgensen Woodhouse]

Yes the clutch is very heat resistant as far as wear and tear. It is for use with a stock or aluminum flywheel, but if you reuse yours you need check your old flywheel for hot spotting and warping before you install a new clutch or else it will be very short lived.

 

[Madduc]

I got my clutch set-up from ROE, Centerforce pressure plate and dual-friction disk along with the Fidanza flywheel for my 8lb roe. Running sticky Kumhoe's and no problem at all with the clutch.

 

[Bigviper]

thanks madduc gone with your surgestion

 

[RobZilla]

I like the chromoly flywheel I got from PartsRack. It's a bit far since your on the other side of the water. Look a few up and consider one as well.