Mark Red GTS Cooper
Enthusiast
Ok all you engine gurus,
Just put a new set of forged Ross pistons in my Gen 2. It only had 4000 mile, but with my super charger and a defective Hyperetectic (sp) piston it was best to go with forged. replaced the rod bearings, new rings everything else left alone.
For the initial break in (ring setting) what oil should I run. I hear that synthetic oil is not good for initial startup, and regular oil should be run, then at 500 miles switch over to
Mobil 1.
The stock piston lost a big chunk ove the first compression ring. Thank you EPA for forcing cat pistons on all 2000 and later cars.
Any thought and words of wisdom would be appreciated!!!
Thanks in advance,
Mark 24 hours from startup
Just put a new set of forged Ross pistons in my Gen 2. It only had 4000 mile, but with my super charger and a defective Hyperetectic (sp) piston it was best to go with forged. replaced the rod bearings, new rings everything else left alone.
For the initial break in (ring setting) what oil should I run. I hear that synthetic oil is not good for initial startup, and regular oil should be run, then at 500 miles switch over to
Mobil 1.
The stock piston lost a big chunk ove the first compression ring. Thank you EPA for forcing cat pistons on all 2000 and later cars.
Any thought and words of wisdom would be appreciated!!!
Thanks in advance,
Mark 24 hours from startup